Graphtec CE6000-60 Vinyl Cutter - …...Graphtec CE6000-60 Vinyl Cutter TURN IT ON Turn the machine...
Transcript of Graphtec CE6000-60 Vinyl Cutter - …...Graphtec CE6000-60 Vinyl Cutter TURN IT ON Turn the machine...
www.picnet.org
Graphtec CE6000-60 Vinyl Cutter
TURN IT ON
Turn the machine on using the power button located on the left side.
LOAD THE PAPER
Unlock the lever down to load the paper.
Rest the roll of paper on the rollers.
www.picnet.org
Make sure it is in position with the stoppers, so the roll of paper doesn’t slide.
Insert the paper.
Move the roller guides to rest on the edge of each side of the vinyl.
www.picnet.org
Lock the lever on the back right side of the machine, by pulling it upward.
SELECT THE MEDIA
Select # 2 – Roll – 2 Current Position.
www.picnet.org
This will measure the piece of vinyl and display the exact dimensions (in inches) on the screen.
When roll of paper has loaded properly the screen should show READY.
www.picnet.org
Open Grapthtec Pro Studio
Load the file
www.picnet.org
Make sure contour marks are there.
www.picnet.org
Select the cutting tool.
The file is positioned on the right bottom corner of the paper.
Select the size and the number of times you want the file to be cut.
www.picnet.org
Making the right selection of the size will make a better use of the paper if that is what you need.
Make sure you leave enough room on the sides of the paper and in between the images.
Now you are ready to send the file to the vinyl cutter.
www.picnet.org
READY TO TRANSFER
Remove your job from the vinyl cutter.
You are now ready to cut the different pieces.
Remove the excess material.
www.picnet.org
PLACE DECAL ON TRANSFER TAPE
Cut a piece of transfer tape big enough to cover your decal.
Remove all bubbles.
Remove transfer tape along with decal.
www.picnet.org
READY TO TRANSFER
Place on final surface, making sure there are no bubbles.
Peel off transfer tape.
www.picnet.org
Your decal is ready.
www.picnet.org
You might be able to use the negative of your decal.
OTHER RESOURCES
• Installation and Setup for the Graphtec CE 6000 Cutter https://www.youtube.com/watch?v=Qt2uOU4ZKcc
• Cutting Vinyl with the Graphtec CE6000-60 and Graphtec Studio https://www.youtube.com/watch?v=eUT7RHz1gXQ
• Graphtec CE6000 Cutter Training - Cutting Master 3 https://www.youtube.com/watch?v=uiIMVqGCHGA
• Graphtec CE6000 Cutting Master 4 [Basic Operation] https://www.youtube.com/watch?v=s3TES_3o6sA
• CE6000 Series Tutorials
https://tinyurl.com/ybv6tzuq