grand-piano_01_i_e_ltr

Assembly Instructions

1: Carefully cut out the parts.2: Make mountain folds and valley folds along the dotted lines, as indicated by the directions.3: Assemble the parts in the order shown by the numbers on the glue tabs. (Read the assembly instruction for more information.)4: Attach the parts in order. (Read the assembly instruction for more information.)5:Your Paper craft model is finished.

What you need

Scissors, tweezers, glue (We recommend craft glue.)Glue stick (used to attach wide surfaces together.)Thread (size 20) (Used to string the piano.)Instant adhesive (Recommended to attach the thread.)

Caution

Keep glue away from small children.Be careful not to cut your fingers when using scissors. Fold the folding lines before gluing.

Scissors line

Valley fold

Mountain fold

Cut in line

Cut out

Glue spot

You can give the piano a more "genuine" appearance if you paint the surface after cutting out the black and yellow parts.

Handy Hint

Notation Key

This model was designed for Papercraft and may differ from the original in some respects. Black and yellow paint has been added to the finished piece in the photo.

When assembling the parts, be sure to carefully read the "AssemblyInstructions" along with the parts sheet.

Grand piano[Assembly Instructions] : Eleven letter sheets

Front lid

Back lidMusic desk

Lock rail

Fallboard

Lockbar

Bridge

Strings

Frame

Lid prop

Heel

BackbottomLeg

Sound boardCaster

Leg plate

Console

Pedals

Pedal plate

Braces Backbottom

Leg

Canon Inc.http://www.canon.com/c-park/PAGE 01

Grand piano : Assembly Instructions Hiroshi Chiba / PAPERART-C

A Making the grand piano's body.

Attach the parts as shown here.




Interlock a and a together.



Interlock b and b together.

As shown here, attach the back sides together.

Cut out.

Cut the part to the correct size, and attach.



Assemble the parts as shown here.




Attach the respective parts as shown here.



Grand piano : Assembly Instructions

Attach the reinforcing beams as shown here.

Hiroshi Chiba / PAPERART-C




Roll up and attach.

Curve part 41 as shown here.


Attach 31 and 32, and make the reinforcing beams.

After gluing 28 and 29 together, attach the reinforcing beams as shown.


Curve.

Curve.



B Making the fallboard.


C Making the backbottom and keys.



Attach the reinforcing beam 46 to back side of 45 as shown here.

Attach.

Cut out the black keys one at a time and attach them.

* This step can be omitted.




A figure of completion of the fallboard.

Fallboard(face)

Fallboard(back)


Attach 62 to the partsmade in 36.

E Making the console and legs.

D Put the parts together to assemble the body.






Slot the fallboard in without applying glue.



Attach the reinforcing beams.


Attach the reinforcing beams to the parts made in 37.

Glue parts.

* Make three of these.







Attach the parts 82, 83. Attach the parts 84, 85.

Attach the parts.

Attach the reinforcing beams 73 to back side of 72 as shown here, and assemble the parts.


Attach the reinforcing beams 75, 76 to back side of 74 as shown here, and assemble the parts.




View from above.

View from underneath.

Make three of these. Make two of these.


Attach the back sides together.



F Making the pedals.


grand-piano_01_i_e_ltr

Documents

Transcript of grand-piano_01_i_e_ltr