Observation of bacteria using staining procedures Simple staining Gram staining.
Gram staining
-
Upload
mariko-burke -
Category
Documents
-
view
149 -
download
5
description
Transcript of Gram staining
![Page 1: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/1.jpg)
Gram staining
![Page 2: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/2.jpg)
Gram stain kits is used to stain
microorganisms from cultures and specimens
by the differential gram method.
The Gram stain is used to differentiate
bacteria into two groups based on the cell color
after staining:
1. Gram +ve bacteria which are bluish purple.
2. Gram ₋ve bacteria which are pinkish red.
![Page 3: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/3.jpg)
Requirements for Gram staining:
1. Glass slides.
2. Bunsen flame.
3. Gram stain kit.
4. Microscope.
5. Wire loop.
![Page 4: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/4.jpg)
Reagents in Gram stain kit:
1. Gram’s crystal violet
solution.
2. Gram’s iodine solution.
3. Gram’s decolorizing
solution.
4. Gram’s safranine solution.
![Page 5: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/5.jpg)
Procedure for making a bacterial smear
![Page 6: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/6.jpg)
Gram Staining method:
Flood the fixed smear with Gram's crystal violet Solution.
Let stand for 2 minutes.
Pour off the stain and gently wash with tape water from a
faucet or a plastic water bottle.
Flood with Gram's iodine Solution. Allow it to remain for 2
minutes (function as mordant which increases interaction
between the cell and dye so that cell is stained more strongly.
Pour off the iodine solution and gently wash with tape water.
Shake off the excess water from the surface.
Decolorize with Gram's Decolorizer Solution (95% Ethanol)
for 3 seconds until the blue dye no longer flows from the
smear. Further delay will cause excess decolorization in the
gram-positive cells.
![Page 7: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/7.jpg)
Gently wash the smear with
tape water.
Counterstain with Gram's
safranin solution for 2
minutes.
Wash off the safranin solution
with water.
The slide is to be shaken to
remove most of the water
and air-dried.
Examine the finished slide
under a microscope .
![Page 8: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/8.jpg)
![Page 9: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/9.jpg)
![Page 10: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/10.jpg)
Ziehl Neelsen staining
![Page 11: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/11.jpg)
The Ziehl-Neelsen (Zn) technique is used to stain
Mycobacterium species including M. tuberculosis, and
M. leprae.
Mycobacteria, unlike most other bacteria, do not stain
well by the Gram technique.
The stain binds to the mycolic acid in the
mycobacterial cell wall. After staining, an acid
decolorizing solution is applied.
This removes the red dye from the background cells,
tissue fibers, and any organisms in the smear except
mycobacteria which retain (hold fast to) the dye and
are therefore referred to as acid fast bacilli “AFB”.
![Page 12: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/12.jpg)
Hot and cold Zn techniquesIn the ‘hot’ Zn technique the phenolic-carbol
fuchsin stain is heated to enable the dye to
penetrate the waxy mycobacterial cell wall.
This heating releases phenol vapours which are
TOXIC.
Techniques which do not heat the stain are
referred to as ‘cold’ techniques.
![Page 13: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/13.jpg)
Requirements Glass slide Bacterial specimen Hot Plate Methanol for smear fixation Staining reagents i.e.a) Primary stain Carbol fuchsin (Red
color)b) Decolorizer (95% Ethanol + 3% HCl)
andc) Counter stain Methylene blue Microscope
![Page 14: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/14.jpg)
Steps in Staining:1. Smear preparation and Fixation Prepare thin smear of given sample
on a glass slide. Allow the slide to air dry.
Fix with methanol: Cover the slide with methanol for 10-
15 minutes until the alcohol completely evaporates.
In this way Mycobacterium becomes completely inactive and attached firmly to the slide.
![Page 15: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/15.jpg)
2. Staining(i) Application of Carbol Fuchsin:Two methods are used i.e.
a) Hot Method Cover the smear with Carbol
Fuchsin and heat the slide by placing it on Hot plate for 3-5 minutes.
Do not allow the stain to boil and dry but it should only evaporate.
By this way stain easily goes into the cell.
![Page 16: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/16.jpg)
b) Cold Method
The smear is flooded with Carbol Fuchsin
along with a wetting agent (Turgitol).
Turgitol reduces surface tension
between the cell wall of mycobacteria
and the stain.
So that stain easily goes into the cell.Following application of primary stain, all cells will appear red.
![Page 17: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/17.jpg)
(ii) Rinse with tap water.
(iii)Add the acid-alcohol decolorizing (95% ethanol and 3% HCl) slowly drop wise until the dye no longer runs off from the smear (20-30 seconds).
(iv) Wash well with tap water.
(v)Counterstain with methylene blue for 2 minute.
(vi) Wash with water, air dry and observe using oil immersion (at 100X) lens.
![Page 18: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/18.jpg)
![Page 19: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/19.jpg)
Kinyoun- Gabett staining kit
Requirements
1.Kinyoun- Gabett staining kit.
2.Glass slides
3. Thermal block (for the hot method).
4.Methanol.
5.Microscope.
![Page 20: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/20.jpg)
Kinyoun- Gabett staining Kit:
1) Kinyoun solution:1. Basic fuchsin.2. Phenol.3. Ethyl alcohol.4. Demineralize
d water.
2) Gabbett solution:1. Methylene
blue.2. Sulfuric acid.3. Ethyl alcohol.4. Demineralize
d water.
![Page 21: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/21.jpg)
Kinyoun- Gabett staining method
Smear preparation and fixation:
1.Smear the sample to be examined in a thin
layer on a clean slide.
2.Allow to dry.
3.Fix with methanol: cover the slide with
alcohol for 10- 15 minutes until the alcohol
completely evaporates.
![Page 22: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/22.jpg)
A. Cold method
1. Place the slide in a staining dish filled with
Kinyoun solution for 3 hours.
2. Rinse with water.
3. Cover the smear with Gabbett solution for 5
minutes.
4. Rinse with water.
7. Wipe the back of the slide clean, and place
it in a draining rack for the smear to air-dry.
![Page 23: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/23.jpg)
B. Hot method
1. Place the slide on a thermal block.
2. Cover the smear with filter paper which is slightly
smaller than the slide.
3. Float the paper with Kinyoun solution.
4. Heat until steam is given off.
5. Leave in contact for 10 minutes. Regularly flood the
filter paper to prevent drying.
6. Rinse with water.
7. Cover with Gabbett solution.
8. Rinse with water.
9. Air dry.
![Page 24: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/24.jpg)
Results
AFB . . . . . . . . . . . . . . . . . . . . Red, straight
or slightly curved rods, occurring singly or
in small groups
![Page 25: Gram staining](https://reader035.fdocuments.in/reader035/viewer/2022081418/5681351d550346895d9c79dc/html5/thumbnails/25.jpg)
Reporting of sputum smears
1. More than 10 AFB/field . . . . . . . . . . . report +++
2. 1–10 AFB/field . . . . . . . . Report ++
3. 10–100 AFB/100 fields . . report +
4. 1–9 AFB/100 fields . . . . . report the exact
number
5. When no AFB are seen after examining 100
fields:
Report the smear as ‘No AFB seen’. Do not report
Negative’ because organisms may be present
but not seen. Up to three specimens (one
collected as an early morning specimen) may
need to be examined to detect M. tuberculosis in
sputum.