GPS Tracker Reference Guide Queclink GB100 · Frotcom International Subject: Privilégios de...
Transcript of GPS Tracker Reference Guide Queclink GB100 · Frotcom International Subject: Privilégios de...
2018-06-01
GPS Tracker Reference Guide
Queclink – GB100
1 OBJECTIVES
This document describes GB100, a plug and play tracking device that aims to provide a reliable and quick
installation solution.
Due to its simplicity and lack of inputs/outputs, this device implements a limited number of Frotcom features:
Basic Tracking;
Adaptive Tracking;
Sleep on Ignition OFF;
External Power Voltage
The GB100 does not have inputs/outputs or the ability to integrate with other sensors. In the other hand,
you will find a device that could be installed quickly and without any special wiring or intervention with the
vehicle’s electrical installations.
GPS Tracker Ref. Guide – Queclink GL300 2018
2 GB100 DESCRIPTION
2.1 TECHNICAL SPECIFICATIONS
The following table lists its technical specifications:
Communication
Modem Quad band
GSM Antenna Internal
Positioning
GPS/GLONASS Receiver U-blox All-In-One GPS receiver (sensitivity: -162dbm)
GPS/GLONASS Antenna Internal
Interface & Telematics Features
3D Accelerometer 3-axis – 100Hz
LEDs 3 (GSM, GPS and power status)
Power Supply
Operating Voltage 8V to 32V DC
General Specifications
Operating Temperature -20/+70 °C
Dimensions (mm) 91.5 x 51.5 x 11.0
Weight 75 g
Backup Battery High Temperature NiMH 200 mAh
Note: This device has protection-rating equivalent to IP65. This means that the device is protected from
total dust ingress and from low-pressure water jets from any direction. However, we strongly recommend
special attention when washing the engine bay.
2.2 INTERFACES
Power LED
GPS LED
GSM LED
GROUND
POWER
3M STICKY PAD
The following interfaces are available:
Please clean the battery surface before installation
GPS Tracker Ref. Guide – Queclink GL300 2018
After connecting the device to the vehicle’s battery, it will start working immediately.
Note: this device has an internal fuse integrated on its PCB, therefore it is not necessary to add a fuse to
the power source connections.
3.4 VERIFICATION
Once turned on, the device will start immediately; the PWR LED will light up and the GPS and GSM LED will
start blinking.
The LEDs are located in the front side as shown in the image:
The LEDs indication has the following states:
GSM Fast flashing Slow flashing ON
Searching GSM GSM network registered SIM needs pin code
GPS OFF Slow flashing Fast flashing ON
GPS receiver OFF No GPS data or error Searching GPS GPS fixed
PWR OFF Slow flashing Fast flashing ON
No external
power and
internal battery
drained
No external
power and
internal battery
below 20%
Has external power and the
internal battery is charging
Has external power and the
internal battery is fully
charged
Please clean the battery surface before installation
Mount the unit with the arrowfacing front of the vehicle