Gimaex TRT With Hydraulik Platform - 14208.1
Transcript of Gimaex TRT With Hydraulik Platform - 14208.1
-
8/3/2019 Gimaex TRT With Hydraulik Platform - 14208.1
1/6
TRT with hydraulic platform
according to German Standard
EN
/
The Technical Rescue Truck corresponds to German
and European Standards.
TRT with hydraulic platform and 7 equipment compartments
The crew of a Technical Rescue Truck consists of (1/1)
or (1/2).
Also a crew of (1/5) can be realised.
It is no independent unit but will normally operated
in connection with a water-carrying Firefighting
Vehicle.The Technical Rescue Truck will mainly be
used for the following operations and tasks:
- Truck accidents
- Rescue from heights or depths
- Supplying of power consumers / thunderstorm
operations
- Accidents at building sites or rail traffic
- Collapses of buildings
- Oil defense operations
- severe accidents at work.
-
8/3/2019 Gimaex TRT With Hydraulik Platform - 14208.1
2/6
TRT
2
Built-in aggregates which are necessary for technical
rescue:
Built-in generator with switch cabinet
The built-in generator will be driven by the vehicles
engine. Its capacity is 23 kVA or 30 kVA. The switch
cabinet is designed in form AA with isolation
monitoring according to German Standard, withoptical and acoustical alarm installation for voltages
230 V and 400 V (16 A and 32 A) with automatic
frequency regulation to 50 Hz.
The switch cabinet is serially mounted in the
equipment compartment above the rear axle.
(At the passengers side)
Hydraulic winch
The hydraulic winch is designed according to
German Standard. The drive will be realised from the
shaft end of the built-in generator as drum or disk
winch with a nominal traction force of up to 80 kN
and usable rope lengths of up to 75 m.
A forward or backward linkage with a traction force
of up to 160 kN (depending on the used chassis) is
standard installed. It will be controlled by cable or
radio remote control unit.
Technical Rescue Truck with pneumatic light mast and Xenon headlights
Pneumatic light mast
The pneumatic light mast with electrically turning
and tilting headlight mounting bridges with 2 or 4 x
1,500 W halogen lamps or optionally also with 4 x 24
V Xenon lamps is mounted on the left hand side of
the front wall.
The light mast can be extended to a light spot
height of approximately 6,000 mm and at the push
of a button it will be automatically retracted and
stored after an operation.
It will be operated by a cable remote control unit,
optionally by a radio remote control unit.
Technical Rescue Truck with 7 equipment compartments
Bodywork
The complete bodywork of the TRT is made of
anodized aluminium profiles which save weight and
which are corrosion resistant.
The framework is coated with aluminium.
Laterally 3 shutters are standard provided. For an
extra charge it is possible to provide 4 shutters.
They can be actuated by double grip or barlock.
The body is deep-drawn between the axles to
facilitate the removal of heavy equipment.
Side view of Technical Rescue Truck with generator switch cabinet and
storage of rescue platform
-
8/3/2019 Gimaex TRT With Hydraulik Platform - 14208.1
3/6
3
Steps
Pullout steps made of safety grates are installed in
the deep-drawn area of the body between the axles.
They are stored in the body which means that they
are protected against contaminations. The covering
behind the rear axle is foldable designed and it is
covered with non-slip cover Safety-Walk.
The steps are necessary for unloading the upper
equipment compartments. If the steps are closed, it
is possible to step directly to the body for unloading
heavy equipment from the equipment compart-
ment floor. This way of unloading is ergonomically
correct, save and it avoids injuries.
It is also possible to deliver conventional steps if
requested.
Roof
The roof is accessible designed. The used aluminium
sheet plate is provided with skid resistance category
R11. The access will be provided by a ladder
which is mounted on the passengers side behind
the drivers cabin. It is standard inclined about 5
degrees. The roof is laterally blinded. It is possible to
additionally install a periphery lighting.
TRT hydraulic platform with split ladder
The roof loading consists of i. e. multipurpose
ladder, exhaust hose for the vehicle, lever, ceiling
hook, binding agent and spreading truck as well
as rubber boat with accessories. Moreover, 1 tomaximum 3 roof cases are mounted on the roof.
The electric installation contains
transistor lamps as equipment compartment
lighting which offer more than the double of
light capacity compared to conventional interior
lights
double hazard warning lights (three-chamber
lights) additionally on top of the rear
open-door warning device
side reflectors consisting of 3 lights per side of the
vehicle
switch cabinet for central electric in the bodywork
circuit breaker instead of safety fuses
non-glare (indirect) roof lighting
Technical design of the interior and the storages
Anodized aluminium profiles will be used for the
interior fittings. Those profiles can be used as a
flexible modular system which enables changes if
necessary and mainly it saves weight.
The heavy equipment is stored on the vehicles floor
and the lightweight equipment is stored below the
roof.
This way of weight distribution benefits the position
of centre of gravity and facilitates the unloading of
equipment. It will mainly be paid attention to a clear
separation of the equipment.
View of steps
-
8/3/2019 Gimaex TRT With Hydraulik Platform - 14208.1
4/6
TRT
4 Slides
Pullout slides are provided for the storage of:
Sliding walls
A smooth-running, vertical sliding wall will be used
for the clear storage of portable searchlights and
flashers.
Drawers
A smooth-running, vertical sliding wall will be used
for the clear storage of portable searchlights and
flashers.
2nd sliding wall:
Lifting cushions, compressed air cylinders and roll of foil with cutter
2nd sliding wall:
Lifting cushions, compressed air cylinders and roll of foil with cutter
1st sliding wall:
Portable searchlights and flashers
1st sliding wall:
Portable searchlights and flashers
Turning bench vice on slide (if requested)
The plasma cutter is stored together with the accessories which are
necessary for operation in an removable aluminium case on a slide
which can be lowered.
View of equipment compartment 3 with pullout drawers and slides
-
8/3/2019 Gimaex TRT With Hydraulik Platform - 14208.1
5/6
5
Removable steel case installed in Sortimo cabinet for nails, screws and
small items
Additionally on request:
Winches on slides which can be lowered
Ventilation device with accessories on slide which can be lowered
Other storages
Part of the equipment is stored in removable
transport and stacking cases made of high-quality
low-pressure polyethylene.
The high stability and ideal handling by 4 grip
openings of the widely oil and chemical resistant
cases offer a save and cheap storage system.
Similar devices can easily be transported to the
operation site.
Additional equipment of rear hydraulic platform
with trolley
The equipment compartment 7 with rear hydraulic platform will be
used for the storage of i. e. 3 mobile trolleys with dead-mans brake
(permanently loaded).
Additional equipment traffic warning system: Flashing arrow system
Nissen type LP 15 with lifting/lowering installation with 2-fold
halogen system (blue) on the rear roof and opened rear.
Multipurpose winch MZ 32 on slide
Example of the rescue platforms storage in equipment compartment 5
A storage on the roof is too dangerous when unloading
-
8/3/2019 Gimaex TRT With Hydraulik Platform - 14208.1
6/6
TRT
Gimaex-Schmitz Fire and Rescue GmbH
Essener Strae 857234 Wilnsdorf, Germany
Tel. +49 (0) 27 39 - 8 09 - 0
Fax +49 (0) 27 39 - 8 09 - 99
eMail [email protected]
www.gimaex-schmitz.com
6
TRT with rear crane
TRT
Additional equipment with lateral awning as weather protection
TRT 18 tons
Features: light mast Super Heavy mounted at the r ear with gas
discharge lamps
TRT crane
Allowed GVWR: 18 tons
Versions of the Technical Rescue Truck:
TRT with 9 equipment compartments
TRT according to German Standard with 9 equipment compar tments
TRT
Storage of the firefighting equipment in aluminium cases according toGerman Standard