GIBEN Matic Series 75 90
-
Upload
ross-gobble -
Category
Documents
-
view
287 -
download
4
description
Transcript of GIBEN Matic Series 75 90
Giben America, Inc. | 2915 Courtyards Drive Suite C, Norcross, GA 30071770-448-9140 | Fax 770-448-9133 | www.giben.com | [email protected]
Saw blade projection 75mm or 90mm
Length of cut 3300 mm or 3800mm
Main saw motor 15 Hp (75mm)
20 Hp (90mm)
Saw carriage speed 5-80 m/min (75mm)
5-150 m/min (90mm)
Pusher 0-80 m/min
Voltage 480 / 3ph / 60Hz
Controller G-Vision XP
On Board Optimizer Included
Giben America, Inc. | 2915 Courtyards Drive Suite C, Norcross, GA 30071 | 770-448-9140 | Fax 770-448-9133 | www.giben.com | [email protected]
THE SAW CARRIAGE travels on two parallel cylindrical
guide bars, positioned on a horizontal plane. Large
diameter “V” rollers (86 mm), with spring loaded
counter rollers, provide smooth linear travel of the saw
carriage, providing optimal distribution of the loads and
weights, very low contact pressure and is virtually free
from wear. The weight and loads acting on the saw
carriage are equally distributed between all the saw
carriage rollers. The saw carriage runs absolutely dry
on its guide bars, and no lubrication or adjustment is
required.
This construction concept has been used and trusted
by Giben for over 30 years and guarantees the
maximum structural rigidity and stability during the
cut cycle.
GRIPPER WITH FLOATING ACTION. The grippers clamp
the primary material book during the working cycle.
3300 cutting length equipped with seven
3800 cutting length equipped with eight
AIR FLOTATION TABLES make material handling light
and easy, which helps to keep the operator efficiency at
the maximum. The air flotation tables are powered by
one large capacity fan, located away from the operator
area.
FRONT AND REAR SQUARE FENCE made of steel on
the left side of the saw bed placed at 90° in respect to
the cutting line.