GENUINE ARTICLE SOLUTION

1. Hold puzzle by Top section, as pictured

in Fig. 1. Lift shuttle and pass Rings 1, 2 and 3 through center of shuttle. Shuttle will now be above Bar A and Ring 3.

2. Turn puzzle so that Top section is pointing to the side and shuttle moves to other side of puzzle. Top remains in center of shuttle. See Fig. 2.

3. Pass tip of shuttle through Ring 3.

4. Pass Ring 1, then Ring 2 up through center and over end of shuttle. See Fig 3.

Make sure Ring 1 is from the same side that you are working on: Bottom section can twist.

Curved side of Top section must remain in the center of the shuttle or Ring 1 might not clear tip of shuttle.

On opposite side of puzzle, make sure Ring 2 does not hook over the eye of the Bottom section.

5. Drop Ring 1 down through center of shuttle.

6. Slide Rings 2 and 3 to the tip of the shuttle, then drop Ring 3 through the shuttle. 7. Bring Ring 1 up through center of shuttle and around tip. See Fig. 4. 8. Slide Rings 1 and 2 to tip of shuttle. Drop Ring 2 through shuttle, then Ring 1 to free

shuttle. See Fig. 5. REASSEMBLY: This puzzle is simple to put back together by following the images and the directions in reverse order. Make sure the shuttle ends up hanging from Bar A. If it ends up hanging on the Bottom section, reassembly was started incorrectly. Take it apart and try again.

Bar A

Bottom section

Figure 1

Ring 2

Shuttle

Top section

Ring 1

Bar B

Ring 3

GENUINE ARTICLE DIAGRAMS

Figure 2

Figure 4

Figure 3

Figure 5