Installation Instructions 004166D Rev E

Tools:(Not all tools required foreach mounting option)

Page 1 of 2

#2 PhillipsScrewdriver

Power Drill

11/32" Dia. Drill Bit

5/16 Wrench

1/16", 5/32" & 1/4"

FYI ® D

ual Monitor A

rm | In

stallation

Instru

ction

s

FYI® DualMonitor Arm

Allen Wrench

FPADUALCC

FYI Dual Monitor Arm

FPADUALTM

6

6

5

5

7

7

62

1

2

4

3

3

4

1

See note below

NOTE: Located in MonitorArm Hardware Pack.

Drill11/32”hole

Attach base assembly to worksurface.

Attach base assembly to worksurface.

Page 2 of 2

004166D Rev E

FPADUALCC

FYI Dual Monitor Arm

FPADUALTM

For further information, please go to the Details website details-worktools.com or call 800.833.0411

P.O. Box 1967 / CD-5E Grand Rapids, MI 49501-1967

©2012 Steelcase Inc. All rights reserved. 12/12

insert cables

cablecover

cablecover

Gently pry off cable cover on the bottom of the arm. Insert cables into arm cavity and through two loops under the arm. Press cover back into place.

3

Attach VESA Bracket to backside of monitor.1 Slide monitor mount assembly onto end of arm until audible “click” is heard. Tighten set screw to prevent removal of monitor.

2

Adjust T-handle to accommodate weight of monitor. The monitor should “float” (neither rise nor fall when the counterbalance is properly adjusted).

4

set screw

releasemechanism

To remove, loosen set screw, depress and hold release mechanism while lifting monitor up and off arm.

Tools Required:• 1/16” Allen Wrench• 5/16” Wrench

• If monitor sinks when installed, pull up the T-handle and turn clockwise until monitor “floats”.

• If monitor rises when installed, pull up the T-handle and turn counter-clockwise until monitor “floats”.

While adjusting the T-handle, the upper arm should be nearly horizontal, to allow the T-handle to turn freely.

If resistance is encountered, raise or lower upper arm, until the T-handle begins to turn easily.

T-handle