Full Face Masks w/Plug-In Connector Instructions for Use March 26 2009 O2 TNG, MRT Trainee - POM 1...
-
Upload
rodger-evans -
Category
Documents
-
view
212 -
download
0
Transcript of Full Face Masks w/Plug-In Connector Instructions for Use March 26 2009 O2 TNG, MRT Trainee - POM 1...
Full Face Masks w/Plug-In Connector
Instructions for Use
March 26 2009 O2 TNG, MRT Trainee - POM1
Panorama Nova RP
What’s What1. Face piece
Connector2. Clip3. Inner Mask4. Visor5. Clamping Frame6. Front Strap7. Head Straps8. Soft body9. Face blank10. ButtonMarch 26 2009 O2 TNG, MRT Trainee - POM2
UseFor masks with visor
wiper: Soak the wiper with the de-misting agent. It must not be actuated when dry.
Hold the full face mask ready: Undo the straps as far as possible.
Put on the PSS BG 4 Closed-Circuit Breathing Apparatus, and press the plug-in connector until it engages
March 26 2009 O2 TNG, MRT Trainee - POM3
Use Put on the mask: Unbutton the strap and
place chin in recess. Fit straps round the
head and pull them back until the front strap rests smoothly on the face.
Position the Mask
1. Tighten the neck straps uniformly
2. Tighten the temple straps uniformly
3. Tighten the front strap if head is fairly small.
March 26 2009 O2 TNG, MRT Trainee - POM4
Check for LeaksTightly compress both
breathing hoses and breathe in until vacuum is produced.
Briefly hold your breath: the vacuum must be maintained.
If it is not, the straps must be tightened further.
The leak test must be repeated twice.
The mask may only be used if perfectly tight!
March 26 2009 O2 TNG, MRT Trainee - POM5
WiperIf the visor mists over, it can be cleared by
wiping. The wiper is activated via a lever on the outside of the visor.
The wiper must then be returned to its basic position in the middle of the visor.
March 26 2009 O2 TNG, MRT Trainee - POM6
After use Disconnect the PSS BG
4 closed circuit breathing apparatus: press the button and simultaneously draw the plug-in connector out of the face piece connector
Remove mask: Slide your index finger under the ends of the neck straps, press the clamps forwards with your thumbs and evenly pull the mask over your head and off your face.
March 26 2009 O2 TNG, MRT Trainee - POM7
Cleaning and DisinfectingCleaning: The mask must be cleaned whenever it
has been used. Position the wiper in the middle of the visor.
The mask must be thoroughly rinsed in lukewarm water containing a little all-purpose Sekusept Cleaner and a cloth.
Rinse under running water.Disinfection: The mask must be disinfected
whenever it has been used. Only use approved disinfectants.
Rinse under running water.Drying: Leave mask to dry in drying cabinet or in air.
March 26 2009 O2 TNG, MRT Trainee - POM8