For STEM / Technology / Industrial Arts Design and ... · PDF filePTC CREO is the world's...
-
Upload
dinhnguyet -
Category
Documents
-
view
213 -
download
0
Transcript of For STEM / Technology / Industrial Arts Design and ... · PDF filePTC CREO is the world's...
Don't Panic STEM curriculum support Technology Teacher Professional Development
by Peter and Ruth Thompson
PTC CREO is the world's leading product development management solution (PDMS). Suitable for the design and development of products in a whole range of subjects in the curriculum.
CREO Advanced is for those who have previously completed a Creo course and wish to go further.
Participants receive 6 hours of face to face training by Australia's most experienced CAD for schools trainers.
This course covers:
‣ Q and A about Creo
‣ Mechanisms
‣ Animation
‣ Surface Modelling
‣ Sheet Materials
ADVANCEDComputer Aided Drawing and Manufacture using PTC CREO
In Newcastle (Hunter) on Saturday 13th May 2017. day following ME Program STEM event 6 hours of accredited training . All meals and training materials included. Register for courses by visiting http://www.dontpanic.net.au/courses/creo-advanced/or dontpanic.net.au and select courses in the menubar
Professional Development For STEM / Technology / Industrial Arts Design and Technology teachers
Peter and Ruth Thompson have delivered professional development for the for over twenty years.
Completing the CREO course will contribute 6 hours of QTC Registered PD addressing 3.3.2, 3.4.2, 5.1.2, 5.3.2, 6.2.2, 6.4.2 from the Australian Professional Standards for Teachers towards maintaining Proficient Teacher Accreditation in NSW.
When: Saturday 13th May 2017 Where: Crowne Plaza Hunter Valley, 430 Wine Country Dr, Lovedale NSW 2325
Time: 8:30 to 4:00 pm
Cost: $350 (inc. GST) contact: [email protected]