FlyBot is an airplane robot.

This robot consists of the DC motor which supplies rotatory power to

the propeller.

FlyFly

1. Insert 7mm support into the wheel and tighten it using a bolt.

AssemblingAssembling

2. Tighten the L2X2 frame on the 7mm support using the nylon nuts.

AssemblingAssembling

3. Put the L2X2 frames connected with wheel on the main frame, and tighten them using bolts and nuts

AssemblingAssembling

4.Assemble the DC motor and motor frame using bolts.

AssemblingAssembling

5. Place the motor frame on the main frame, and tighten it using bolts

AssemblingAssembling

6. Using a 4hole frame, a 5hole frame, and motor frame make a T-shaped, and tighten them using only bolts.

AssemblingAssembling

7. Put the T-shaped frame under the main frame, and tighten it using bolts and a 7mm support.

AssemblingAssembling

8. Fix the cab nut at the 7mm support, and tighten the buzzer board at the motor frame using a bolt

AssemblingAssembling

9. After connecting the 5hole frame to the wheel guide, fit it into the DC motor.

AssemblingAssembling

10. Locate the battery case on the main frame, and then assemble them together with bolts and supports.

AssemblingAssembling

11. Fix the CPU board and the DC motor drive board together with bolts and nuts.

AssemblingAssembling

12. Place the LEDs on the 8hole frames, fix them together using bolts and nuts.

AssemblingAssembling

13. Put the 8hole frame on the CPU board and tighten them using bolt and support.

AssemblingAssembling

14. After connecting 20mm supports to the CPU board, fix the middle frame with nuts.

AssemblingAssembling

15. Put the CPU board into the 35mm supports, and then tighten it using nuts.

AssemblingAssembling

16. Connect the power cable of battery case to the power connector of the CPU board. Connect the DC motor cable to the A spot of the DC motor drive board.

AssemblingAssembling

17. Connect 3pin cable to the OUT port No.1 and No.2 of CPU board and ports No.1 and No.2 of the DC motor drive board. Connect OUT ports No.3, No.4, No.5 and No6 to the red LED, the orange LED, the yellow LED, and the green LED using 3pin cable.

AssemblingAssembling

18. Join the OUT port No7 and the buzzer board using 3pin cable. FlyBot is completed.

AssemblingAssembling