10

Installation: (TKW128-17D)

1..Outlook Specification

① NUT ②Gasket ③Rack Mount ④Log Screw ⑤Hanging Rod

⑥Expanding Rubber Staff ⑦Cross Sunk Screw ⑧Back Board ⑨Hook Groove

.

Hanging Stick

GasketNUTRack Mount Log screwExpanding rubber staff

Back Board

2. Installation Steps

Note: Installation are made only to interface of suitable hardness

Cut a 458Wx328Hx68(deep) mm recess in the wall board to accommodate the Back Board. The

recess in the wall should be open below the Back Board to allow cables to enter the bottom of the

11

unit. The wall should be of suitable strength to support TV.

1、Drill holes of the right size.

2、Fill in the rubber.

3、Put Embed Board into the recess hold.

4、Fix 3.5x30KM Stainless screw to fix the Back board.

5、Lift the TV carefully to put the rod into the hook groove to be stuck.

1 2Installation surface

Note:measure the position before drilling Embed Size

Mirror LCD TV IR Back Board Wires Out