FLUIDS, HEAT and MASS TRANSFER, MECHANICAL and CIVIL ENGINEERING

Proceedings of the 11th International Conference on Fluid Mechanics (FLUIDS '15)

Proceedings of the 11th International Conference on Heat and Mass Transfer (HMT '15)

Proceedings of the 6th European Conference of Civil Engineering (ECCIE '15) Proceedings of the 2nd International Conference on Aeronautical and

Mechanical Engineering (AEME '15)

Budapest, Hungary December 12-14, 2015

Recent Advances in Mechanical Engineering Series | 17

ISSN: 2227-4596 ISBN: 978-1-61804-358-0

FLUIDS, HEAT and MASS TRANSFER, MECHANICAL and CIVIL ENGINEERING

Proceedings of the 11th International Conference on Fluid Mechanics (FLUIDS '15) Proceedings of the 11th International Conference on Heat and Mass Transfer (HMT '15) Proceedings of the 6th European Conference of Civil Engineering (ECCIE '15) Proceedings of the 2nd International Conference on Aeronautical and Mechanical Engineering (AEME '15) Budapest, Hungary December 12-14, 2015

Published by WSEAS Press www.wseas.org Copyright © 2015, by WSEAS Press All the copyright of the present book belongs to the World Scientific and Engineering Academy and Society Press. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of the Editor of World Scientific and Engineering Academy and Society Press. All papers of the present volume were peer reviewed by no less that two independent reviewers. Acceptance was granted when both reviewers' recommendations were positive.

ISSN: 2227-4596 ISBN: 978-1-61804-358-0

FLUIDS, HEAT and MASS TRANSFER, MECHANICAL and CIVIL ENGINEERING

Proceedings of the 11th International Conference on Fluid Mechanics

(FLUIDS '15) Proceedings of the 11th International Conference on Heat and Mass Transfer

(HMT '15) Proceedings of the 6th European Conference of Civil Engineering (ECCIE '15)

Proceedings of the 2nd International Conference on Aeronautical and Mechanical Engineering (AEME '15)

Budapest, Hungary December 12-14, 2015

Editor: Prof. Nikos E. Mastorakis, Technical University of Sofia, Bulgaria Committee Members-Reviewers: Najib Altawell Valeriy Perminov M. M. Noor Petr Mastny George D. Verros Hamed Ziaeipoor Guoxiang Liu Oguz Arslan Calbureanu Popescu Madalina Xenia Alina Adriana Minea Mihaela Dudita Damelys Zabala Elena Scutelnicu Krisztina Uzuneanu Heimo Walter Muhammad Musaddique Ali Rafique Vasile Cojocaru Cristian Patrascioiu Isaac Yeboah Dan Victor Cavaropol Konstantin Volkov Miguel Angel Vigil Berrocal Hessam Ghasemnejad Mihaela Toderas Corneliu Bob Adrian Ciutina Valeriu Stoian Luis Loures Nabil Mohareb Ahmet Arslan Kemal Tutuncu Humar Kahramanli Saad Bakkali Zohreh Salavatizadeh Karim Shirazi Ahadollah Azami Ali Dashti Shafiei Harry Coomar Shumsher Rughooputh Ana Maria Tavares Martins Konstantinos Vogiatzis Catarina Luisa Camarinhas Reza Fathipour Khaled Galal Ahmed Sorin-Codrut Florut Ali Salehipour Oprita Razvan José Nunes Feridoun Nahidi Azar Ayca Tokuc Mehdi Seyyed Almasi Jon Burley Maria Bostenaru Dan Walid Oueslati Al Emran Ismail

Table of Contents

Transient Numerical Simulation of the Melting Behavior of NaNO3 in a Latent Thermal Energy Storage Device Using a Wire Matrix for Enhancing the Heat Transfer

9

Martin Koller, Heimo Walter, Michael Hameter

Verification of the Elastic Deformation of Soil around a Rigid Base 18

Kamil Burkovic, Martina Janulikova

Formation of Hydrodynamic Structure of Fluidized Bed Optimal for Burning Fuels with High Volatile Matter Content, Based on Results of External Heat Exchange Local Coefficients Study

22

Rafail Isemin, Dmitry Klimov, Sergey Kuzmin, Aleksandr Mikhalev, Valentin Konyakhin, Oleg Milovanov, Natalia Muratova Measurement of the Heat Transfer Decrement of Different Wall Structures 29

Akos Lakatos

The Behaviour of the Spatial Timber Truss 35

Jana Rumlova, Roman Fojtik

The Estimates of Slow Flow Velocity Profile in the Window between the Balls 40

Darya Sandulyak, Anna Sandulyak, Maria Polismakova, Alexander Sandulyak, Vladimir Matveev

Photogrammetry Based 3D Object Reconstruction of Multicopter Aerial Photography 47

Andras Molnar, Daniel Stojcsics

High Speed Crushing Behaviour of GFRP Composite Tubes 53

A. Rabiee, H. Ghasemnejad

A Polynomial Short-Term Traffic Flow Prediction Model 57

Nicolae Ciont, Rodica Dorina Cadar, Mihai Iliescu, Melania Rozalia Boitor

Modeling of the Fluid Flow to the Production Well in the Presence of Discontinuities in the Reservoir

65

Elena Andriyanova, Vladimir Astafev

Comparison of the Difference between Creep of Young and Maturece Cement Paste with Fly Ash

69

Pavel Padevet, Petr Bittnar

Damage Assessment, Damage Control and Monitoring by UAV in Agriculture 75

Andras Molnar, Daniel Stojcsics, Istvan Lovas, Laszlo Csemez

Teaching Learning Based Optimization Algorithm for Analyses of Trusses Considering Elastoplastic Behavior

81

Yusuf Cengiz Toklu, Rasim Temür, Gebrail Bekdas

Two-Phase Filtration Model for Nonlinear Viscoplastic Oil and Hard Water Drive 86

Anastasia Markelova, Valeria Olkhovskaya

Fluids, Heat and Mass Transfer, Mechanical and Civil Engineering

ISBN: 978-1-61804-358-0 7

SLAM Algorithm for Mobile Robot Localization with RGB-D Camera 89

Laszlo Somlyai, Zoltan Vamossy

Experimental Verification Of Load-Carrying Capacity In Case Of Steel Post-Installed Expansion Anchors Subjected To A Tension Loading

95

Michal Strba, Marcela Karmazinova

Investigation of Thermal Effects on Analyses of Truss Structures via Metaheuristic Approaches 99

Yusuf Cengiz Toklu, Gebrail Bekdas, Rasim Temür

Monitoring of Water Infiltration in Autoclaved Aerated Concrete Masonry Construction Blocks by Electrical Impedance Spectrometry

106

Sanita Rubene, Martins Vilnitis

A Three-Part Mixed Boundary Value Problem for a Heated Plate 112

Belkacem Kebli, Belkacem Agagna

Sliding Joint in Civil Engineering 125

Martina Janulikova, Pavlina Mateckova, Petr Mynarcik

Urban Mobility Indicators and Road User Behavior Assessment by Means of GPS Technology in Cluj-Napoca, Romania

129

Rozalia Boitor, Rodica Cadar, Mihai Iliescu, Gavril Hoda, Nicolae Ciont

Material Properties of Clay Mortar for Use in Building Structures 135

Pavel Padevet, Tereza Otcovska

Aerodynamic Study of the Ahmed Body in Road-Situations Using Computational Fluid Dynamics

140

R. Manimaran

Numerical Investigations of Free-Convection within Wind Turbine Nacelle Operating in Hot Climate

148

Arezki Smaili, Mohammed A. Mahdi, Lamine M. Ouahchia

Develop Trip Generation Model for Alexandria City – Egypt 153

Ahmed Elkafoury, Abdelazim M. Negm, Mohamed H. Aly, Mahmoud F. Bady

Flood River Simulation Risk Map 161

O. Hadj-Sahraoui, F. Berrichi

Verification and Actual Behavior of Shear Connection of Composite Steel and Concrete Structures Using Pcb-W Technology

168

V. Privrelova

Authors Index 174

Fluids, Heat and Mass Transfer, Mechanical and Civil Engineering

ISBN: 978-1-61804-358-0 8

Authors Index

Aly, M. H. 153 Manimaran, R. 140 Andriyanova, E. 65 Markelova, A. 86 Astafev, V. 65 Mateckova, P. 125 Bady, M. F. 153 Matveev, V. 40 Bekdas, G. 81, 99 Mikhalev, A. 22 Belkacem, A. 112 Milovanov, O. 22 Belkacem, K. 112 Molnar, A. 47, 75 Berrichi, F. 161 Muratova, N. 22 Bittnar, P. 69 Mynarcik, P. 125 Boitor, M. R. 57, 129 Negm, A. M. 153 Burkovic, K. 18 Olkhovskaya, V. 86 Cadar, R. D. 57, 129 Otcovska, T. 135 Ciont, N. 57, 129 Ouahchia, L. M. 148 Csemez, L. 75 Padevet, P. 69, 135 Elkafoury, A. 153 Polismakova, M. 40 Fojtik, R. 35 Privrelova, V. 168 Ghasemnejad, H. 53 Rabiee, A. 53 Hadj-Sahraoui, O. 161 Rubene, S. 106 Hameter, M. 9 Rumlova, J. 35 Hoda, G. 129 Sandulyak, Al. 40 Iliescu, M. 57, 129 Sandulyak, An. 40 Isemin, R. 22 Sandulyak, D. 40 Janulikova, M. 18, 125 Smaili, A. 148 Karmazinova, M. 95 Somlyai, L. 89 Klimov, D. 22 Stojcsics, D. 47, 75 Koller, M. 9 Strba, M. 95 Konyakhin, V. 22 Temür, R. 81, 99 Kuzmin, S. 22 Toklu, Y. C. 81, 99 Lakatos, A. 29 Vamossy, Z. 89 Lovas, I. 75 Vilnitis, M. 106 Mahdi, M. A. 148 Walter, H. 9

Fluids, Heat and Mass Transfer, Mechanical and Civil Engineering

ISBN: 978-1-61804-358-0 174