REFERENCES

Checkel, M.D. and Handford, D.I. Flaring Efficiency Calculator. Flaring Diluted Methane-

Based Gases in a Crosswind. (2010).

IPCC Fourth Assessment Report (AR4) by Working Group 1(WG1). (2007).

Kostiuk, L., Johnson, M., and Thomas, G. University of Alberta Flare Research Project: Final

Report. University of Alberta, Department of Mechanical Engineering, September. (2004).

McDaniel, M. Flare Efficiency Study. Prepared by Engineering-Science, Inc. for the U.S.

Environmental Protection Agency Office of Research and Development. (1983).

Pohl, J.H. and Soelberg, N.R. Evaluation of the Efficiency of Industrial Flares: H2S Gas

Mixtures and Pilot Assisted Flares. U.S. Environmental Protection Agency Air and Energy

Engineering Research Laboratory. Report number EPA/600/S2-86/080. (1986).

Smith, J.M., Van Ness, H.C., and Abbott, M.M. Introduction to Chemical Engineering

Thermodynamics, 6th

edition print. (2000).

United States Environmental Protection Agency, Emissions Factors & AP 42, Compilation of

Air Pollutant Emission Factors. (1995).

Weather Underground. Web. 10 June 2010. .

Flare Efficiency Estimator and Case Studies R-1

http://ipcc-wg1.ucar.edu/wg1/wg1-report.htmlhttp:www.wunderground.comACKNOWLEDGMENTSABSTRACT AND BENEFITSTABLE OF CONTENTSLIST OF FIGURESLIST OF TABLESLIST OF ACRONYMSEXECUTIVE SUMMARYCHAPTER 1.0CHAPTER 2.0CHAPTER 3.0CHAPTER 4.0CHAPTER 5.0CHAPTER 6.0CHAPTER 7.0APPENDIX AREFERENCES