FLAGG-AIR 340HT - Septic Tank Parts · The Flagg-Air 340HT Aerator has been independently tested...

2
2-YEAR WARRANTY FLAGG-AIR 340HT AERATORS WWW.FLAGG-AIR.COM 2-YEAR WARRANTY Features Models TM Required 7-amp electrical mini-breaker included. High impact plastic suds restrictor Stainless steel shaft High impact plastic aspirator Handle with integrated cord storage Corrosion resistant bronze counter shaft Rust resistant epoxy painted motor The Flagg-Air 340HT Aerator has been independently tested for performance in original manufacturer’s tanks and proven to meet or exceed the oxygen transfer rates of original manufacturer’s aerator units. The Flagg-Air™ 340HT Septic Aerator is a dependable shaft- style aerator providing optimal aeration. The higher CFM air flow and low RPM (1750) of the Flagg-Air provides optimal aeration for your tank. 340HT-J 340HT-N Alternative compatible replacement for the Jet* Aerator. 12-inch diameter top brackets fits 10-inch diameter tank riser opening. Alternative compatible replacement for the Norweco Singulair* Aerator. 15-inch diameter top brackets fits 12-inch diameter tank riser opening. Low rpm, high torque fully enclosed continuous duty motor • High quality stainless steel shaft • High quality sealed bearings • Corrosion resistant bronze counter shaft • Sealed end plates • Totally enclosed non- ventilated continuous duty motor • Protected handle & cord storage Order/Questions : 800-778-1540 or 636-583-1608 Septic Tank Parts

Transcript of FLAGG-AIR 340HT - Septic Tank Parts · The Flagg-Air 340HT Aerator has been independently tested...

Page 1: FLAGG-AIR 340HT - Septic Tank Parts · The Flagg-Air 340HT Aerator has been independently tested for performance in original manufacturer’s tanks and proven to meet or exceed the

WWW.FLAGG-AIR.COM2-YEAR WARRANTY

FLAGG-AIR 340HTAERATORSWWW.FLAGG-AIR.COM

2-YEAR WARRANTY

Features

Models

TMTM

Required 7-amp electrical mini-breakerincluded.

High impact plastic suds restrictor

Stainless steelshaft

High impactplasticaspirator

Handle with integrated cord storage

Corrosion resistant bronze counter shaft Rust resistant

epoxy painted motor

The Flagg-Air 340HT Aerator has been independently tested for performance in original manufacturer’s tanks and proven to meet or exceed the oxygen transfer rates of original manufacturer’s aerator units.

The Flagg-Air™ 340HT Septic Aerator is a dependable shaft-style aerator providing optimal aeration. The higher CFM air flow and low RPM (1750) of the Flagg-Air provides optimal aeration for your tank.

340HT-J

340HT-N

Alternative compatible replacement for the Jet* Aerator. 12-inch diameter top brackets fits10-inch diameter tank riser opening.

Alternative compatiblereplacement for the Norweco Singulair* Aerator. 15-inch diameter top brackets fits 12-inch diameter tank riser opening.

• Low rpm, high torque fully enclosed continuous duty motor

• High quality stainless steel shaft• High quality sealed bearings• Corrosion resistant bronze counter shaft• Sealed end plates• Totally enclosed non- ventilated continuous duty motor

• Protected handle & cord storage

Order/Questions : 800-778-1540 or 636-583-1608

Septic Tank Parts

Page 2: FLAGG-AIR 340HT - Septic Tank Parts · The Flagg-Air 340HT Aerator has been independently tested for performance in original manufacturer’s tanks and proven to meet or exceed the

FLAGG-AIR 340HT AERATORS

SpecificationsFeatures

The Flagg-Air™ 340HT aerator produces high CFM air flow at lower RPM providing more efficient operation and cost savings over the life of the aerator.

• Low rpm, high torque fully enclosed continuous duty motor• Protective motor cover with handle & cord storage• Corrosion resistant bronze counter shaft• High quality stainless steel shaft• High quality sealed bearings • Sealed end plates• Double sealed end caps

1/6HP

Note: If you are replacing an existing aerator you can determine if you have a Jet or Norweco-Singulair aerator by looking for the brand logo on the control panel, side of aerator motor or vent cap on center of tank lid.

340HT-J 340HT-NFits opening for Jet * Norweco *

Model Specifications

Unit Installation

Unit Dimensions

46” (340HT-J, 340HT-N)

12”

(340

HT-J

)

ASPIRATOR TIPHIGH-IMPACTSUDS RESTRICTOR

5/8” DIA. STAINLESSSTEEL SHAFT

POWDER COATED STEEL MOUNTING BRACKETS

FULLY-ENCLOSEDMOTOR

RUBBER VIBRATIONRESTRICTORS

15”

(340

HT-N

)

12” (340HT-J)

15” (340HT-N)

TOP OF UNITHANDLE

MOUNTINGBRACKET

* Jet is a registered trademark of Jet Inc. * Norweco/Singulair is a registered trademark of Norwalk Wastewater Equipment Company, Inc.

RPMVoltsAmp

115 1750

4.7

Dimensions 46" x 12" 46" x 15"Weight 28 lbs. 28 lbs.

Replacement parts available at:www.septictankparts.com or toll free 800-778-1540.

Septic Tank Parts. • 7059 Hwy 47 (shipping) P.O. Box 632 (mail) • Union, Missouri 63084 • Tel: 800-778-1540 Fax 636-583-6432 • [email protected] • www.flagg-air.com

Septic Tank Parts reserves the right under its product improvement policy to change construction or design detail without obligation regarding previous models and to furnish equipment when so altered without reference to illustrations or specifications used here.

Copyright © Septic Tank Parts 2018All rights reserved.

CORROSION-RESISTANTCOUNTER SHAFT

HANDLE�WITH CORD STORAGE