FITTING INSTRUCTIONS FOR RYCO CABIN AIR FILTER RCA191C … · 2018. 7. 17. · INSTRUCTION SHEET...

1
INSTRUCTION SHEET IS191C GUD Automotive Pty Ltd 29 Taras Ave Altona North Victoria 3025 Australia www.rycofilters.com.au GUD (NZ) Holdings Limited 626A Rosebank Road Avondale Auckland, New Zealand www.ryco.co.nz GUD Automotive - A Division of FITTING INSTRUCTIONS FOR RYCO CABIN AIR FILTER RCA191C VOLKSWAGEN POLO (9N & 6R) (pictured), AUDI A1 & SKODA ROOMSTER 1 2 3 4 The filter housing sits underneath the glove box on the right hand side of footwell. Once housing has been identified slide plastic braces towards the centre of the lid to release it as indicated in the picture above. Filter housing lid released. Remove dirty filter from housing slowly as dirt may be released onto the carpet. Clean the housing of possible objects like leaves and insert new filter in the right direction. Check flow direction indicated on filter. Re-fit components in reverse order.

Transcript of FITTING INSTRUCTIONS FOR RYCO CABIN AIR FILTER RCA191C … · 2018. 7. 17. · INSTRUCTION SHEET...

Page 1: FITTING INSTRUCTIONS FOR RYCO CABIN AIR FILTER RCA191C … · 2018. 7. 17. · INSTRUCTION SHEET IS191C GUD Automotive Pty Ltd 29 Taras Ave Altona North Victoria 3025 Australia ˜lters.com.au

INSTRUCTION SHEET IS191C

GUD Automotive Pty Ltd29 Taras Ave Altona NorthVictoria 3025 Australiawww.ryco�lters.com.au

GUD (NZ) Holdings Limited626A Rosebank Road AvondaleAuckland, New Zealandwww.ryco.co.nz

GUD Automotive - A Division of

FITTING INSTRUCTIONS FOR RYCO CABIN AIR FILTER RCA191CVOLKSWAGEN POLO (9N & 6R) (pictured),

AUDI A1 & SKODA ROOMSTER

1 2

3 4

The filter housing sits underneath the glove box on theright hand side of footwell. Once housing has been identifiedslide plastic braces towards the centre of the lid to release itas indicated in the picture above.

Filter housing lid released.

Remove dirty filter from housing slowly as dirt may be releasedonto the carpet. Clean the housing of possible objects likeleaves and insert new filter in the right direction. Check flowdirection indicated on filter.

Re-fit components in reverse order.