FITTING INSTRUCTIONS FOR RYCO CABIN AIR FILTER RCA182P ... · Auckland, New Zealand GUD Automotive...

1
INSTRUCTION SHEET IS182P GUD Automotive Pty Ltd 29 Taras Ave Altona North Victoria 3025 Australia www.rycofilters.com.au GUD (NZ) Holdings Limited 626A Rosebank Road Avondale Auckland, New Zealand www.ryco.co.nz GUD Automotive - A Division of FITTING INSTRUCTIONS FOR RYCO CABIN AIR FILTER RCA182P MITSUBISHI OUTLANDER (ZG & ZH) (pictured), ALFA ROMEO 159, BRERA, SPIDER & MIITSUBISHI ASX (GA), LANCER (CJ) The cabin air filter housing is located behind the glovebox. To gain acces, the glovebox has to first be removed. Remove objects from compartment and unclip the strut shown in pic above. With the strut unclipped, proceed to release the glove box from its securing hinge. Simply apply some pressure to the far upper corners towards the inside of the compartment as indicated in the pic and slowly drop the unit. With the glove box unit out of the way the housing will be easily identifiable sitting on top of the blower fan. Remove the housing lid and pull out the dirty filter and clean area from large objects trapped in the housing. Insert the new filter in the right air flow direction. Look for arrow on one of the sides of the filter to identify air flow direction. Re-fit all components in reverse order.

Transcript of FITTING INSTRUCTIONS FOR RYCO CABIN AIR FILTER RCA182P ... · Auckland, New Zealand GUD Automotive...

Page 1: FITTING INSTRUCTIONS FOR RYCO CABIN AIR FILTER RCA182P ... · Auckland, New Zealand GUD Automotive - A Division of FITTING INSTRUCTIONS FOR RYCO CABIN AIR FILTER RCA182P MITSUBISHI

INSTRUCTION SHEET IS182P

GUD Automotive Pty Ltd29 Taras Ave Altona NorthVictoria 3025 Australiawww.ryco�lters.com.au

GUD (NZ) Holdings Limited626A Rosebank Road AvondaleAuckland, New Zealandwww.ryco.co.nz

GUD Automotive - A Division of

FITTING INSTRUCTIONS FOR RYCO CABIN AIR FILTER RCA182PMITSUBISHI OUTLANDER (ZG & ZH) (pictured),

ALFA ROMEO 159, BRERA, SPIDER & MIITSUBISHI ASX (GA), LANCER (CJ)

The cabin air filter housing is located behind the glovebox.To gain acces, the glovebox has to first be removed.Remove objects from compartment and unclip the strutshown in pic above.

With the strut unclipped, proceed to release theglove box from its securing hinge. Simply apply somepressure to the far upper corners towards the insideof the compartment as indicated in the pic and slowlydrop the unit.

With the glove box unit out of the way the housing will beeasily identifiable sitting on top of the blower fan.Remove the housing lid and pull out the dirty filter and cleanarea from large objects trapped in the housing.

Insert the new filter in the right air flow direction.Look for arrow on one of the sides of the filter to identifyair flow direction. Re-fit all components in reverse order.