Exceder LED3 and PowerPath The perfect combination

Up to 264 Exceder LED3 devices per PowerPath (PS-8-LP)

Fully synchronized

Up to 33 15 cd Exceder LED3 devices per NAC @ 1 amp 870 ft. @ 14 AWG and 1380 ft. @ 12 AWG

EOLR

Up to 8 NACs @ 1 amp each

Wheelock PowerPath and Exceder LED3

PowerPath power supply has 3 times the device capacity than the competition

Eaton is a registered trademark.

All other trademarks are property of their respective owners.

Eaton1000 Eaton BoulevardCleveland, OH 44122United StatesEaton.com

EatonLife safety & mass notification solutions273 Branchport AvenueLong Branch, NJ 07740Eaton.com/massnotification

© 2018 EatonAll Rights ReservedPrinted in USAPublication No. SA450008ENMarch 2018

Diagnostics

Follow us on social media to get the latest product and support information.

GROUND FAULT

Having a hard time finding which circuit has a ground fault?

PowerPath solution

• Ground fault detection of each of 8 NACs

• Ground fault detection for the auxiliary output circuit

• Ground fault detection for the synchronization bus power

• Ground fault detection for each relay

• Ground fault detection by conductor - positive or negative

Most extensive ground fault detection in the industry

DIAGNOSTICS

What other diagnostic capabilities does the power supply have?

PowerPath solution

• Open, short and over current indications for each of the 8 NACs

• Auxiliary output current limit indication

• AC power on, AC loss trouble, battery power on, battery trouble

• Internal diagnostics: Microprocessor, battery charger, logic board power, synchronization bus power.

Up to 37 distinguishable diagnostic codes available

The new low cost, high value equipment leader

Current is no longer an obstacle. Distance limitation for each NAC is now the key factor due to voltage drop.

Equipment cost is only part of the story. What about installed cost?

Exceder LED3 and PowerPath: The perfect combination

Best diagnostics, most NACs, largest amount of LED devices in the industry

PS-8-LP CORE FEATURES

• 8 amps of NAC power (up to 3 amps/NAC circuit)

• 4 Class B NACs or 2 Class A (no extra equipment)

• Optional expansion to 8 Class B or 4 Class A (same box)

• 2 Class B or 2 Class A inputs

• Input to output follow mode and audible silence capability

• Dip switch programming & LED latching option

• 2 Relays - AC fail and common trouble (N/O, N/C)

• Programmable AC loss relay delay (30 sec or 170 min)

• PowerPath to PowerPath panel synchronization

• 2.5 amp auxiliary power with reset capability