EV CONTAINER CORPORATION - REVOLUTIONIZING THE BEVERAGE INDUSTRY Copyright @ EV Container...

EV CONTAINER CORPORATION- REVOLUTIONIZING THE BEVERAGE INDUSTRY

Copyright @ EV Container Corporation

EV

EVkeg Purge & Fill for Homebrewers

EVKeg Purge – seal check & liner deployment

- Set up a line with a pour valve on the coupler outlet as shown- Open the keg valve and purge the keg



- Shut the pour valve. The back pressure build up will open the liner in the keg- Once the liner is deployed, pressure will rise in the keg to the regulator set pressure- Shut off the cylinder valve. If the keg holds pressure the fitment seal is functional



- If pressure is lost, carefully remove the handle and reset the fitment seal


EVKeg Fill - Shut off the keg valve to hold the CO2 in the keg- Disconnect the liners and remove the coupler. - Remove the ball lock retainer and ball from the outlet port


EVKeg Fill - Remove the check valve from the CO2 port


EVKeg Fill - Replace the check valve with a flat gasket as shown


EVKeg Fill - Attach the fill line to the outlet port as shown- Attach the serving valve to the CO2 port


EVKeg Fill - Open the keg valve and begin the gravity fill- At the start of the fill, shut off the serving valve to create backpressure and maintain full

deployment of the liner- Once pressure has been established, open the valve as needed to reduce foam


EVKeg Fill - When the liner is deployed and fully supported by the keg walls, the keg can be

pressurized to the full operating pressure of 45PSI.


EVkeg – contact us

www.evcontainer.com

EV Container Corporation2148 Beechcraft Road

Unit 300VacavilleCA 95688

415-460-5341


EVkeg – made in the USA

Thank you


EV CONTAINER CORPORATION - REVOLUTIONIZING THE BEVERAGE INDUSTRY Copyright @ EV Container...

Documents

Transcript of EV CONTAINER CORPORATION - REVOLUTIONIZING THE BEVERAGE INDUSTRY Copyright @ EV Container...