Triple spark ignition engine comparison with single and twin spark ignition engines.
Engine Ignition Analyzer · Dwell time (systems with spark plug wire) Engine RPM Maximum and...
Transcript of Engine Ignition Analyzer · Dwell time (systems with spark plug wire) Engine RPM Maximum and...
Quick, powerful and easy to use
Plug the appropiate sensor pick-up into the flexible probe
Select the number of cycles of the engine to be measured
Select the measurement type and display format
Place the pick-up on top of the ignition module, or over
the spark plug wire
The GTC505 will automatically detect and adjust all
parameters to provide accurate measurements and
clear graphs
Displays and measures
Waveforms in real time
Spark plug peak voltage
Spark burn (firing) time
Coil primary current ramp time (COP and CNP)
Dwell time (systems with spark plug wire)
Engine RPM
Maximum and minimum readings
How it works
The GTC505 Engine Ignition Analyzer is a handheld
instrument designed from the ground up for the diagnosis
and performance measurement of all types of spark ignition
systems, from conventional to the newest Coil on Plug in
use.
The latest generation of ARM Cortex processors together
with proprietary hardware and digital signal processing
technology are combined to provide with all the information
required for quick and reliable diagnosis within seconds,
without lengthy setups, nor the long learning curve of
conventional lab scopes or engine analyzer.
Capable of displaying and measuring the following in real
time: secondary ignition waveform, primary coil current
ramp time, dwell time, spark burn time and RPM. It also
provides two innovative and unique display formats used to
compare measurements between cylinders, and to look at
data for hundreds of spark events over time in order to
detect intermittent problems, misfires and other
performance issues which are very difficult to detect using
conventional scopes.
This hand held device is powered by a rechargeable lithium
battery, which provides up to 8 hours of battery life and
uses a fast response 3.5” color TFT display with a bright
backlight and wide viewing angle.
Quick powerful and easy to use
505Engine Ignition Analyzer
Useful for troubleshooting:
Non-starts
Misfires
Intermittent problems
Primary and secondary coil circuits faults
Fouled or damaged spark plugs
Damaged spark plug wires
Product designed andmanufactured in CanadaProduct designed andmanufactured in Canada
15/03/16
Displays and measures spark burn (firing) time, dwell time, current ramp
time, RPM, and spark plug peak voltage.
Selectable view of all measurements modes as chart, compare graph, analog gauge / digital readout and waveforms.
Displays secondary ignition waveforms.
Candle stick graph compares maximum,
minimum and average measurements
of several cylinders.
Analog gauge and digital readout with maximum and minimum.
Chart mode used for detecting intermittent or infrequent failures and misfires.
Specially designed pick-ups for coil on plug ignition modules (left) and spark plug wires (right).
Works on 2 and 4 cycle, and waste spark ignition systems engines.
and misfires.spark plug wires (right).
Other GTC products
General Technologies Corp. #121-7350 72nd Street Delta, BC V4G 1H9 - Canada
Toll Free: 800-440-5582 / Tel: 604-952-6699 / Fax: 604-952-6690 www.gtc.ca / [email protected]
“ G T C ” a n d “ S m a r Ta c h ” a r e t r a d e m a r k o f G e n e r a l Te c h n o l o g i e s C o r p . © 2 0 1 6 G e n e r a l Te c h n o l o g i e s C o r p .
ST05Oxygen Sensor
Tester and
Simulator
FF310FaultFinder
Open and Short Circuit
Finder and Tracer
CT8002Professional Cordless
Computer-Safe
Circuit Tester
LTX SeriesFrom -20° up to 1400 °F
Infrared Thermometers
with Laser Sight
CM Series
From 1 mA to 1000 A
AC/DC Current
Clamp Meters
Technical Specifications Display: Color 3.5” TFT (320x240 pixels)
Flexible probe: 12” (30 cm) long with
interchangeable COP and SPW pick-up
Power source: Rechargeable LiFePO4 battery
Battery life: 6 hrs of continuous operation
Power saving: Automatic power off
Physical dimensions: 6.5"(H) x 4.9"(W) x 1.4"(D)
or 165 mm x 124 mm x 36 mm (without probe)
Weight: 14.8 oz or 420 g (without probe)
RPM measurement
Range: 120 to 19,999 RPM
Resolution: 1 RPM
Accuracy: ±0.5% + 1 LSD
Spark (peak) voltage
Range: 0 to 50 kV
Resolution: 0.1 kV
Repetitivity: ±0.2 kV
Spark burn (firing) time
Range: 0 to 10.0 mS
Resolution: 0.1 mS
Accuracy: ±0.1 mS + 1 LSD
Ignition primary current ramp time (COP mode)
Range: 0 to 10.0 mS
Resolution: 0.1 mS
Accuracy: ±0.1 mS + 1 LSD
Dwell time (spark plug wire)
Range: 0 to 10.0 mS
Resolution: 0.1 mS
Accuracy: ±0.1 mS + 1 LSD
GTC505 set includes:
GTC505
Flexible probe
Coil on plug (COP) pickup
Spark plug wire (SPW) pickup
USB micro cable and AC charger adapter
Protective rubber holster
Hard carrying/storage case
User’s manual
1 year parts and labor warranty
TA SeriesEngine Tachometers
and Ignition Analyzers
TA110 Laser Tachometer and
Counter
Printed in Canada