ENER.G50 Technical Data Sheet
1
5 GENERAL DESCRIPTION: - Enclosure Type: Internal - Fuel Type: Natural Gas - Minimum Methane Number: 80 - Electrical Output: 51 kW - Heat Output (Exhaust Temp Cooled to120°C): 78 kW - Fuel Input Net/Gross (CV 10 kWh/Nm³): 163/180 kW - Min/Max Dynamic Gas Pressure: 20/45 mbar - Max Flow/Return Water Temp: 90/80°C PRIME MOVER: - Type: Reciprocating Engine - Combustion Cycle: 4-stroke Spark Ignition - Cylinders: 4 - Speed: 1500 rpm - Nox Emissions with/without Cat: 250/6500 mg/Nm³ - CO Emissions with/without Cat: 350/6500 mg/Nm³ - Aspiration: Natural GENERATOR: - Type: Synchronous - Frequency: 50 Hz - Voltage: 400 V - Efficiency: 92.6 % HEAT RECOVERY SYSTEM: - Fully closed primary water circuit - Exhaust gas heat exchanger in primary circuit - PHE between primary & secondary circuits - Primary water pump - Auto heat output modulation CONTROL & PROTECTION: - On board computer control, protection and monitoring - Engine stop/start, synchronising, modulation - Mechanical, electrical and thermal protection - 70+ parameters monitored, historical data recorded - 2 way communication between unit and head office - BMS interface signals STANDARD EQUIPMENT: - Exhaust silencers (industrial & residential grade) - Secondary water pump OPTIONAL EQUIPMENT / CONFIGURATION: - Heat rejection equipment / controls - Export control panel - Heat and gas metering - Modbus Interface Card - Catalytic converters for very low emissions - Generator only (no heat recovery) - Island mode operation - CHP absorption chiller packages - Noise levels stated are free field. - Electrical output is based on output at the generator terminals at a power factor of 0.95. - Energy quantities subject to reduction when modulating in response to external conditions. - We reserve the right to alter the Engine Type, at any time, to meet the system specifications. - Performance figures are subject to original Engine manufacturer's declared performance, tolerances and test conditions. - Technical Datasheets are subject to change, without notice, due to out commitment to ongoing product improvement. ENER·G Combined power Limited are part of the ENER·G Group. Issued: 26/07/2010 ENER·G House, Daniel Adamson Road, Manchester M50 1DT - T: 00 44 161 745 7450 E: [email protected] W: www.energ.co.uk ENER▪G 50M (Integral to Unit) ENER-G 50M Technical Datasheet
description
ASDAS
Transcript of ENER.G50 Technical Data Sheet
-
50M
GENERAL DESCRIPTION:
- Enclosure Type: Internal
- Fuel Type: Natural Gas
- Minimum Methane Number: 80
- Electrical Output: 51 kW
- Heat Output (Exhaust Temp Cooled to120C): 78 kW
- Fuel Input Net/Gross (CV 10 kWh/Nm): 163/180 kW
- Min/Max Dynamic Gas Pressure: 20/45 mbar
- Max Flow/Return Water Temp: 90/80C
PRIME MOVER:
- Type: Reciprocating Engine
- Combustion Cycle: 4-stroke Spark Ignition
- Cylinders: 4
- Speed: 1500 rpm
- Nox Emissions with/without Cat: 250/6500 mg/Nm
- CO Emissions with/without Cat: 350/6500 mg/Nm
- Aspiration: Natural
GENERATOR:
- Type: Synchronous
- Frequency: 50 Hz
- Voltage: 400 V
- Efficiency: 92.6 %
HEAT RECOVERY SYSTEM:
- Fully closed primary water circuit
- Exhaust gas heat exchanger in primary circuit
- PHE between primary & secondary circuits
- Primary water pump
- Auto heat output modulation
CONTROL & PROTECTION:
- On board computer control, protection and monitoring
- Engine stop/start, synchronising, modulation
- Mechanical, electrical and thermal protection
- 70+ parameters monitored, historical data recorded
- 2 way communication between unit and head office
- BMS interface signals
STANDARD EQUIPMENT:
- Exhaust silencers (industrial & residential grade)
- Secondary water pump
OPTIONAL EQUIPMENT / CONFIGURATION:
- Heat rejection equipment / controls
- Export control panel
- Heat and gas metering
- Modbus Interface Card
- Catalytic converters for very low emissions
- Generator only (no heat recovery)
- Island mode operation
- CHP absorption chiller packages
- Noise levels stated are free field.
- Electrical output is based on output at the generator terminals at a power factor of 0.95.
- Energy quantities subject to reduction when modulating in response to external conditions.
- We reserve the right to alter the Engine Type, at any time, to meet the system specifications.
- Performance figures are subject to original Engine manufacturer's declared performance, tolerances and test conditions.
- Technical Datasheets are subject to change, without notice, due to out commitment to ongoing product improvement.
ENERG Combined power Limited are part of the ENERG Group.
Issued: 26/07/2010 ENERG House, Daniel Adamson Road, Manchester M50 1DT - T: 00 44 161 745 7450 E: [email protected] W: www.energ.co.uk
EN
ER
G 50M
(Integral to Unit)
ENER-G 50MTechnical Datasheet
