Emergency Spill & Pollution Call Points for the Water Industry
-
Upload
envirogen-ireland-ltd -
Category
Documents
-
view
215 -
download
3
description
Transcript of Emergency Spill & Pollution Call Points for the Water Industry
Emergency Spill & Pollution Call Points for the Water Industry
A standalone or fully integrated Spill Alert System can be created using the RDNET 1000
Wireless Call Points. These units can be placed at strategic locations where spills are most
likely to occur such as refuelling stages or dosing plants.
Unlike a burglar alarm panic buttons or fire alarm brake glass unit – the RDNET is fully
weatherproof and includes twin location LEDs that permits it to be found easily in poor
visibility. The activation button is covered by a waterproof membrane which is further
protected by a lift up hinged flap to prevent accidental operation. The two status LEDs
also show the status of the call point – green for standby and red for in alarm.
The message broadcast by the Call Point can be used to illuminate a flashing beacon,
sound a klaxon, trigger our Alertcomms messaging system and most importantly close
the sites Pollution Containment Valve/s such the FlapstopperTM or DrainstopperTM.
Being both wireless and battery powered installation of the call points could not be
simpler and where hazardous areas are involved the Call Points can be supplied with ATEX
Zone 2 certification.
There is no practical limit to the number of call points that can be installed. Plus with
planning sites can be zoned so that either a particular Pollution Containment valve is
closed or multiple ones.