Edge BlendConstant radius edge blend

Handlebar

Edge Blend - Variable

5 mm radius for 25% length of the edge

10 mm radius for the next 25%

15 mm radius for the next 25%

5 mm radius for the last 25%

Select Edge Blend → Variable Radius option → select an edge

Edge Blend - VariableSelect 4 points and specify the radius and the % length of the edge for each section

Select Inferred icon and pick the end point of the edge

Specify Radius and % length

Point 1 – specify 5 mm radius and 75% Arc Length

Note: Arc length is counted down from 100%. So for section 1, 5 mm radius for the first 25% of length, you should specify 75% for Arc Length

Edge Blend - VariablePoint 2 - 10 mm radius for the next 25%

Pick a point on the edge and specify radius 10 mm and 50% for Arc Length and then enter

Point 3 - 15 mm radius for the next 25%, pick a point on the edge and specify 15 mm radius and 25% Arc Length

Edge Blend - Variable

Point 4 - 5 mm radius for the last 25%, pick the end point of the edge and specify 5 mm radius and 0% (default) Arc Length

Face Blend

First surface

Direction for the first surface

Second surface

Direction for the second surface

1st surface

2nd surface

Face BlendShape option

Circular

Conic

Face BlendBlend profile could also be controlled with Radius Method option Law Controlled with

Linear Law Type

Law Controlled with Cubic Law Type

Face Blend

Select Tangency Constraint

Select Coincident Edge

Coincident Edge

Select Tangent Curve

Tangent Curve

Soft Blend5 steps needed to create a soft blend

1 - Select surface one

2 - Select surface two

Reverse direction if needed

Soft Blend3 - Select tangent curve 1

4 - Select tangent curve 2

Soft Blend

Face Blend

5 - Select tangent curve 2