Easy Ways Of Using The Heat Press Transfer machine
-
Upload
hitransfers -
Category
Documents
-
view
16 -
download
3
Transcript of Easy Ways Of Using The Heat Press Transfer machine
Easy Ways of Using the Heat Press Transfer Machine
1. Determine the temperature at which the decal should be applied and make certain the heat press used can accommodate it. Also make certain the temperature and pressure provided by the machine are sufficient to adhere the decal to the transfer item. 2. Prepare the press for operation. Ensure the power cord is connected properly and that all necessary switches are turned on and set as outlined in equipment instructions. 3. Set the press thermostat to the proper temperature for the decal and the item onto which it's being transferred. In most instances, there will be a light that will remain on until the machine is heated to the set temperature. When the light goes off, the machine is ready.
4. Set the press thermostat to the proper temperature for the decal and the item onto which it's being transferred. In most instances, there will be a light that will remain on until the machine is heated to the set temperature. When the light goes off, the machine is ready.
6. Set the press thermostat to the proper temperature for the decal and the item onto which it's being transferred. In most instances, there will be a light that will remain on until the machine is heated to the set temperature. When the light goes off, the machine is ready.7. Close the heat press, clamping down the heating element pad over the top of the transfer item on the transfer pad. Lock the press into place in the closed position.
8. Adjust heat press pressure for the type of item on which the decal is being placed. Thin clothing items may require less pressure than thicker items such as computer mouse pads.9. Set the heat press timer for the amount of time needed to complete the transfer successfully. If uncertain about the amount of time required, refer to the instructions provided with the decal as well as the temperature recommendations for the transfer item itself.
10. Let the press remain closed until the timer goes off. Immediately open the press slowly, being careful to keep the sublimation decal paper? and transfer item from sticking to the heat element pad. It should remain in place on the transfer rubber pad.
More info pls visit: www.hitransfer.comCompany name:Nanjing Hi Transfer Digital Technology Co.,LimitedTel: 86-25-85862106Fax: 86-25-85862106Mail: [email protected]: www.hitransfer.com