EARTH’S HYDROSPHERE

EARTH’S HYDROSPHERE CYCLEHydrological cycleIsolation, or energy (in the form of heat and light) from the sun, provides the energy necessary to cause evaporation from all wet surfaces including oceans, rivers, lakes, soil and the leaves of plants. Water vapor is further released as transpiration from vegetation and from humans and other animals.Aquifer drawdown or overdrafting and the pumping of fossil water increases the total amount of water in the hydrosphere[2] that is subject to transpiration and evaporation thereby causing accretion in water vapour and cloud cover which are the primary absorbers of infrared radiation in the earth's atmosphere. Adding water to the system has a forcing effect on the whole earth system, an accurate estimate of which hydrogeological fact is yet to be quantified.

HYDROSPHERE A hydrosphere (from Greek ὕδωρ - hydor, "water" and σφαῖρα - sphaira, "sphere") in physical geography describes the combined mass of water found on, under, and over the surface of a planet.

The total mass of the Earth's hydrosphere is about 1.4 × 1018 tonnes, which is about 0.023% of the Earth's total mass. About 20 × 1012 tonnes of this is in the Earth's atmosphere (the volume of one tonne of water is approximately 1 cubic metre). Approximately 75% of the Earth's surface, an area of some 361 million square kilometres (139.5 million square miles), is covered by ocean. The average salinity of the Earth's oceans is about 35 grams of salt per kilogram of sea water (35 ‰).

EARTH’S SYSTEM

Earth's outgassing that was responsible for creation of its hydrosphere, ...

Possible scenario of the mantle petroliferous fluid migration.

The Four Spheres of the Earth

Lithosphere

The lithosphere is the solid, rocky crust covering entire planet. This crust is inorganic and is composed of minerals. It covers the entire surface of the earth from the top of Mount Everest to the bottom of the Mariana Trench.

HydrosphereThe hydrosphere is composed of all of the water on or near the earth. This includes the oceans, rivers, lakes, and even the moisture in the air. Ninety-seven percent of the earth's water is in the oceans. The remaining three percent is fresh water; three-quarters of the fresh water is solid and exists in ice sheets

Biosphere

The biosphere is composed of all living organisms. Plants, animals, and one-celled organisms are all part of the biosphere. Most of the planet's life is found from three meters below the ground to thirty meters above it and in the top 200 meters of the oceans and seas.

AtmosphereThe atmosphere is the body of air which surrounds our planet. Most of our atmosphere is located close to the earth's surface where it is most dense. The air of our planet is 79% nitrogen and just under 21% oxygen; the small amount remaining is composed of carbon dioxide and other gasses.

IMAGES OF FOUR SPHERES

WATER POLLUTION

Water pollution is the contamination of water bodies (e.g. lakes, rivers, oceans and groundwater). Water pollution occurs when pollutants are discharged directly or indirectly into water bodies without adequate treatment to remove harmful compounds.Water pollution affects plants and organisms living in these bodies of water; and, in almost all cases the effect is damaging not only to individual species and populations, but also to the natural biological communities.

Causes

The specific contaminants leading to pollution in water include a wide spectrum of chemicals, pathogens, and physical or sensory changes such as elevated temperature and discoloration. While many of the chemicals and substances that are regulated may be naturally occurring (calcium, sodium, iron, manganese, etc.) the concentration is often the key in determining what is a natural component of water, and what is a contaminant. High concentrations of naturally-occurring substances can have negative impacts on aquatic flora and fauna.

Oxygen-depleting substances may be natural materials, such as plant matter (e.g. leaves and grass) as well as man-made chemicals. Other natural and anthropogenic substances may cause turbidity (cloudiness) which blocks light and disrupts plant growth, and clogs the gills of some fish species.Many of the chemical substances are toxic. Pathogens can produce waterborne diseases in either human or animal hosts. Alteration of water's physical chemistry includes acidity (change in pH), electrical conductivity, temperature, and eutrophication. Eutrophication is an increase in the concentration of chemical nutrients in an ecosystem to an extent that increases in the primary productivity of the ecosystem. Depending on the degree of eutrophication, subsequent negative environmental effects such as anoxia (oxygen depletion) and severe reductions in water quality may occur, affecting fish and other animal populations.

This diagram shows the many things that can pollute the water.

WATER CONTAMINATION

The contaminants which can contribute to pollution are a wide spectrum of pathogens, chemicals, and physical or sensory changes such as elevated temperature and discoloration. A bacterial indicator of pollution would be coliform bacteria. To view a list of microorganisms present in polluted waters, Organic water contaminants would include detergents, disinfection by-products, herbicides, insecticides, food processing waste, petroleum hydrocarbons, and various chemical compounds that can be found in hygiene and cosmetic products. Inorganic water pollutants include acidity (ex. from power plants), ammonia (ex. from food-processing waste), fertilizers, heavy metals (ex. from cars), silt, and chemical waste (ex. industrial by-products). Macroscopic pollution which are large, visible items that pollute the water are shipwrecks, nurdles, and trash.

Three categories of water pollution

Point sourcesPoint source pollution refers to contaminants that enter a waterway from a single, identifiable source,

such as a pipe or ditch. Examples of sources in this category include discharges from a sewage treatment plant, a factory, or a city storm drain. The U.S. Clean Water Act (CWA) defines point source for regulatory enforcement purposes. The CWA definition of point source was amended in 1987 to include municipal storm sewer systems, as well as industrial storm water, such as from construction sites.

Non–point sources

(NPS) pollution refers to diffuse contamination that does not originate from a single discrete source. NPS pollution is often the cumulative effect of small amounts of contaminants gathered from a large area. A common example is the leaching out of nitrogen compounds from fertilized agricultural lands. Nutrient runoff in storm water from "sheet flow" over an agricultural field or a forest are also cited as examples of NPS pollution.

Contaminated storm water washed off of parking lots, roads and highways, called urban runoff, is sometimes included under the category of NPS pollution. However, this runoff is typically channeled into storm drain systems and discharged through pipes to local surface waters, and is a point source. However where such water is not channeled and drains directly to ground it is a non-point source.

Groundwater pollution

Interactions between groundwater and surface water are complex. Consequently, groundwater pollution, sometimes referred to as groundwater contamination, is not as easily classified as surface water pollution.[7] By its very nature, groundwater aquifers are susceptible to contamination from sources that may not directly affect surface water bodies, and the distinction of point vs. non-point source may be irrelevant. A spill or ongoing releases of chemical or radionuclide contaminants into soil (located away from a surface water body) may not create point source or non-point source pollution, but can contaminate the aquifer below, defined as a toxin plume. The movement of the plume, called a plume front, may be analyzed through a hydrological transport model or groundwater model. Analysis of groundwater contamination may focus on the soil characteristics and site geology, hydrogeology, hydrology, and the nature of the contaminants.

Water Pollution

Water pollution occurs when a body of water is adversely affected due to the addition of large amounts of materials to the water. The sources of water pollution are categorized as being a point source or a non-source point of pollution. Point sources of pollution occur when the polluting substance is emitted directly into the waterway. A pipe spewing toxic chemicals directly into a river is an example. A non-point source occurs when there is runoff of pollutants into a waterway, for instance when fertilizer from a field is carried into a stream by surface runoff. 

Types of Water Pollution

Toxic Substance -- A toxic substance is a chemical pollutant that is not a naturally occurring substance in aquatic ecosystems. The greatest contributors to toxic pollution are herbicides, pesticides and industrial compounds. 

Organic Substance -- Organic pollution occurs when an excess of organic matter, such as manure or sewage, enters the water. When organic matter increases in a pond, the number of decomposers will increase. These decomposers grow rapidly and use a great deal of oxygen during their growth. This leads to a depletion of oxygen as the decomposition process occurs. A lack of oxygen can kill aquatic organisms. As the aquatic organisms die, they are broken down by decomposers which leads to further depletion of the oxygen levels. 

A type of organic pollution can occur when inorganic pollutants such as nitrogen and phosphates accumulate in aquatic ecosystems. High levels of these nutrients cause an overgrowth of plants and algae. As the plants and algae die, they become organic material in the water. The enormous decay of this plant matter, in turn, lowers the oxygen level. The process of rapid plant growth followed by increased activity by decomposers and a depletion of the oxygen level is called eutrophication.

Thermal Pollution -- Thermal pollution can occur when water is used as a coolant near a power or industrial plant and then is returned to the aquatic environment at a higher temperature than it was originally. Thermal pollution can lead to a decrease in the dissolved oxygen level in the water while also increasing the biological demand of aquatic organisms for oxygen. 

Ecological Pollution -- Ecological pollution takes place when chemical pollution, organic pollution or thermal pollution are caused by nature rather than by human activity. An example of ecological pollution would be an increased rate of siltation of a waterway after a landslide which would increase the amount of sediments in runoff water. Another example would be when a large animal, such as a deer, drowns in a flood and a large amount of organic material is added to the water as a result. Major geological events such as a volcano eruption might also be sources of ecological pollution. 

A polluted river draining an abandoned copper mine on Anglesey

MANILA BAY

BEFORE NOW