DT200 - WE POWER. YOU ADVENTURE. | Coleman Powersports · 2020. 8. 14. · before operating this...
Transcript of DT200 - WE POWER. YOU ADVENTURE. | Coleman Powersports · 2020. 8. 14. · before operating this...
DT200ASSEMBLY INSTRUCTIONS
PLEASE NOTE THAT THIS IS NOT THE OWNER’S MANUAL BUT THE ASSEMBLY INSTRUCTIONS ONLY.
BEFORE OPERATING THIS DRIFT TRIKE, MAKE SURE THE OPERATOR HAS READ AND UNDERSTANDS THE OWNER’S MANUAL, WARNING LABELS AND IS FAMILIAR WITH ALL OF THE DRIFT TRIKE CONTROLS.
FOR QUESTIONS REGARDING THE ASSEMBLY OF THIS DRIFT TRIKE, PLEASE CALL COLEMAN POWERSPORTS 888-405-8725
POWERSPORTS
REV090117
Foot RestsSeat
Safety Net
Frame
Owner’s Manual
PARTS
Tool Kit
Attach frame together using M8 x 25 Allen head BoltsM8 lock washersM8 Acorn Nuts
FRAME ASSEMBLY
M8 x 25 Bolts
M8 Lock Washers
M8 Acorn Nuts
Hardware
Tools
6mm Allen wrench
Torque bolts to 20 ft.lbs.
M8 x 30 bolts Tools6mm Allen wrench
Hardware
Install handlebars usingM8 x 30 Allen head bolts and M8 Lock washers.
HANDLEBAR ASSEMBLY
M8 x 30 bolts
M8 Lock Washers
M8 Lock Washer
Torque bolts to 10 ft.lbs
Zip Tie
Zip Tie
Zip Tie
Zip tie all cables to frame in locations noted in photos. Make sure no cables are in a location which could be smashed or pinched by the handlebars or seat.
Cut off ends of Zip ties once installed.
ZIP TIE CABLES
Zip Ties
Safety Netassembly
SAFETY NET INSTALLATION
M8 x 30 boltsHardware
M8 Lock Nuts
Tools
10mm and 12mm Wrench
Install Safety net asssembly using M8 x 30 Bolts and M8 lock nuts.
Tighten Bolts snug.
M8 x 30 Bolt
M8 Lock Nut
SEAT INSTALLATION
M6 x 12 bolts
M6 x 16 bolts
M6 x 16 bolt
M6 x 12bolt
Install the seat using M6 x 12 front bolts and M6 x 16 rear bolts and M6 rear Lock nuts.
M6 lock nuts
10mm wrench5mm Allen Wrench
Hardware
Tools
M6 lock nut
Tighten bolts snug
M8 x 20 boltsHardware
10mm wrenchTools
M8 x 20 Bolt
Install Foot rests using M8 x 20 bolts.
Torque Bolts 14 ft.lbs.
FOOT REST INSTALLATION
! WARNINGTHIS IS NOT THE OWNER’S MANUAL, THIS IS THE ASSSEMBLY INSTRUCTIONS ONLY.
THE OWNER’S MANUAL, INCLUDED WITH THIS DRIFT TRIKE, HAS ALL INFORMATION REQUIRED FOR SAFETY, ENGINE PREPERATION, PRE-RIDE INSPECTION AND STARTING INSTRUCTIONS.
NEVER START THE ENGINE WITHOUT READING AND FULLY UNDERSTANDING THE OWNER’S MANUAL AND ALL WARNINGS.
IF YOU DID NOT GET AN OWNER’S MANUAL WITH THIS DRIFT TRIKE, PLEASE CALL COLEMAN POWERSPORTS AT 888-405-8725.