DRILL RIG - toshiba.com · DRI RIG MOTOR Insulation System • Toshiba Proven VPI • Class H...
Transcript of DRILL RIG - toshiba.com · DRI RIG MOTOR Insulation System • Toshiba Proven VPI • Class H...
Toshiba’s AC Drill Rig Motor is a force ventilated three-phase alternating-current induction motor for use in the oil and gas industry for land based drilling rig, mud pump, draw-works duty, and fracking applications.
Standard Features:
• 1150 HP, 40 Hz / 1500 HP, 45 Hz
• -40°C to 45°C Ambient Temperature
• IP44, Force Ventilated Blower Cooled Enclosure
• 6-Pole Stator with Form Wound Windings
• VPI, Class H Insulation, Mica-Kapton System
• Six RTDs; 100 Ohm Platinum, Two per Phase
• Copper Chromium Alloy Rotor Bars
• Insulated Bearings on Both Ends with Ground Strap
• Field-modifiable IP56 Main Terminal Box with Bus Bar
Connections for Main Cables & Terminals for RTDs;
Suitable for F-1 & F-2
• Space Heater
• Keyless Tapered 4340 Alloy Shaft
• Single Shaft Extension with Oil Field Hub
• Drop-in Replacement
1150 HPContinuous Rating
Intermittent Drawworks Duty Cycle
Volts (AC) 600/690 600/690
Current (A) 1088 1290
HP 1150 1400
RPM @ Rated HP 800 to 1800 800 to 1600
Torque (lb-ft) 7645 9367
1500 HPContinuous Rating
Intermittent Drawworks Duty Cycle
Volts (AC) 600/690 600/690
Current (A) 1316 1655
HP 1500 1830
RPM @ Rated HP 900 to 1200 800
Torque (lb-ft) 8902 12244
DRILL RIGLOW VOLTAGE MOTOR
DRILL RIG MOTOR
Insulation System• Toshiba Proven VPI• Class H Insulation, Mica-Kapton System• Form Wound Inverter Duty Magnet Wire• Exceeds NEMA MG1 Part 31
Construction• Ductile Cast Iron for Low Temperature• Keyless Tapered 4340 Alloy Shaft (1.25” per foot)• IP44, Force Ventilated Blower Cooled• Field-modifiable IP56 Main Terminal Box• -40°C to 45°C Ambient Temperature
Cooling System• Air Intake with Kinetic Dust Separation• Blower Assembly Providing Over 3900 SCFM
Options• Differential Pressure Switch• Shaft Mount Encoder Ready• Rhyno-49 Quick Connectors• Bearing RTDs: Pt100, Two per Bearing• IP56 Main Terminal Box- F3 Position• Class 1, Division 2, Group ABCD, T3 • Class 1, Zone 2, Groups IIA,IIB, T3
BUILT FOR DRILLING RIG, MUD PUMP, DRAW-WORKS DUTY, & FRACKING APPLICATIONS
© 2018 Toshiba International Corporation • Motors & Drives Division • 13131 West Little York Road • Houston, Texas 77041 USA • Tel +713-466-0277 US 1-800-231-1412 • Rev. 180822
www.toshiba.com/tic
GX7M DrivePremium Performance When Paired with the Toshiba GX7M Drive
• Designed for Drilling • Modular Construction• Pack In/Out Modules
with improved MTTR• Compact Design