Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26

CSFB FROM LTE WITH DMCR & Without DMCR

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 2

CSFB subscribers roam with preference on LTE access, no CS-voice service available (only PS based services)

Fallback triggered to overlapping CS domain whenever voice services are requested and resumed LTE access for PS services after call completion.

CSFB is enhanced with support for DMCR to decrease the call set up time. If the DMCR capability is on and the DMCR is activated in SIB3 then the UE is allowed to send message on RACH or act on received message on FACH before complete reading of SIB11/SIB12/SIB19.

The feature Deferred Measurement Control Reading provides faster call setup time for CS Fallback from LTE with release with redirect.

1. Introduction

1. Purpose

This instruction is used for the CSFB From LTE with DMCR (FAJ 121 1610 ) activation procedure by MOS Script on software level W12B in RNC side.

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 3

The following Feature/parameter

Node Mo Parameter Required

RNC RncFeature CsFallbackLte 1

RNC UtranCell dmcrEnabled 1

DMCR Feature

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 4

Node Mo Parameter New

RNC Rnc Feature LteCellReselection.featureState 1 (Activate)

RNC Sid schedulingBlockEnabled 1

RNC Sid sib19.sib19RepPeriod 256

RNC UtranCell AbsPrioCellRes.cellReselectionPriority 2

RNC Sid SIB11 12

RNC Sid sib5RepPeriod 32

RNC RncFunction loadSharingRrcEnabled TRUE

RNC UtranRelation loadSharingCandidate define

RNC UtranRelation loadSharingThreshold 0

RNC UtranCell interFreqFddMeasIndicator 0

Parameter at RNC

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 5

DESCRIPTIONCS fallback triggered UE release to WCDMA - Idle Mode.

1.PRECONDITION•Enable licence key file CsFallbackLte (CXC 403 0106) in the RNC•The timer on the eNodeB to control user inactivity is “tInactivity Timer” which is set to 10 sec. UE performs the normal attach and goes into idle state due to user inactivity.

set rcs tinactivitytimer 10•The deactivation of DMCR feature done at the Utrancell level.

set Utrancell=x dmcrenabled 0

1.CSFB triggered UE release to WDCMA while user is Idle Mode due to inactivity - Mobile originating without DMCR.

1. TEST INSTRUCTION Action: Attach relevant WCDMA UE and LTE UE. Action: Make LTE UE IDLE Mode Action: Make call from WCDMA UE to LTE UE

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 6

CSFB Procedure

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 7

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 8

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 9

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 10

CSFB Delay

CSFB call setup time standards

MT： Extend service request To Alerting.

Delay 2.2 s from extended service request to CC Alerting Delay 3.6 s from CC alerting to CC connect. Total CSFB time is 5.8 s

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 11

1.DESCRIPTION1.Verify the gain of 1 second in CS call setup using CSFB with DMCR in WCDMA/LTE test environment.2.PRECONDITION

. •Enable licence key file CsFallbackLte (CXC 403 0106) in the RNC•The timer on the eNodeB to control user inactivity is “tInactivity Timer” which is set to 10 sec. UE performs the normal attach and goes into idle

state due to user inactivity•The activation of DMCR feature done at the Utrancell level.set Utrancell=x dmcrenabled 1We should see SIB3 message to notify about feature activation

CSFB triggered UE release to WDCMA while user is Idle Mode due to inactivity - Mobile originating with DMCR

1. TEST INSTRUCTION Action: Attach relevant WCDMA UE and LTE UE. Action: Make LTE UE IDLE mode Action: Make call from WCDMA UE to LTE UE

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 12

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 13

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 14

CSFB Delay

CSFB call setup time standards

MT： Extend service request To Alerting.

Delay 2.6 s from extended service request to CC Alerting Delay 3.9 s from CC alerting to CC connect. Total CSFB time is 6.5 s

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 15

DESCRIPTION While PS call on LTE UE, CS fallback triggered UE release to WCDMA. PRECONDITION

•Enable licence key file CsFallbackLte (CXC 403 0106) in the RNC•The deactivation of DMCR feature done at the Utrancell level.

set Utrancell=x dmcrenabled 0

TC-3 CSFB triggered UE release to WDCMA while PS call is happening - Mobile originating without DMCR.

Action: Attach relevant WCDMA UE and LTE UE. Action: Make PS call on LTE UE Action: Make call from WCDMA UE to LTE UE

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 16

CSFB Procedure

1.MT CSFB call attempt with extend service request. The UTRAN frequency is included in RRC Connection Release message.

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 17

CSFB Procedure

2. Routing Area Update

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 18

3. Authentication, call proceeding and radio bearer setup.

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 19

. Call alerting and setup success

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 20

2nd call from WCDMA UE to LTE UE in PS mode

CSFB Time : 6.4 S

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 21

CSFB Delay

CSFB call setup time standards

MT： Extend service request To Alerting.

Delay 2.6 s from extended service request to CC Alerting Delay 3.8 s from CC alerting to CC connect. Total CSFB time is 6.4 s

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 22

1.Verify the gain of 1 second in CS call setup using CSFB with DMCR in WCDMA/LTE test environment.2.PRECONDITION

•Ensure that the preconditions as tested in 3.1 are followed for the appropriate frequency eNodeB/eUtranCell being tested. •Enable licence key file CsFallbackLte (CXC 403 0106) in the RNC•The activation of DMCR feature done at the Utrancell level.

set Utrancell=x dmcrenabled 1

1. CSFB triggered UE release to WDCMA while PS call is happening - Mobile originating with DMCR.

Action: Attach relevant WCDMA UE and LTE UE. Action: Make PS call on LTE UE Action: Make call from WCDMA UE to LTE UE

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 23

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 24

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 25

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 26

CSFB Delay

CSFB call setup time standards

MT： Extend service request To Alerting.

Delay 2.47 s from extended service request to CC Alerting Delay 3.23 s from CC alerting to CC connect. Total CSFB time is 5.7 s

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 27

Result

IDLE: DMCE Disabled total CSFB time 5.8 s

IDLE : DMCR enabled Total CSFB time 6.5 s

PS: DMCR disabled Total CSFB time 6.4

PS: DMCR enabled Total CSFB time 5.7 s

Abhijeet Kumar NAK 2014 - PRESENTATION TITLE - DEPARTMENT AUTHOR - 2014-04-26 28

THANKS