DGI+VT+Print+Head
description
Transcript of DGI+VT+Print+Head
DGI VTPrint Head AdaptationFor both VT II and VT IV
The DGI VT printers use Xaar XJ-128 128/80 print heads, but they are mounted in a harness. The procedure for swapping a print head is real simple and straightforward. Just have a look at the inforgraphic below to see the various components and guidelines.
REMOVE THE OLD PRINT HEAD FROM THE HARNESSThe old Print Head needs to be removed from the harness prior to installing the new one. You start by disconnecting the ink line connector . Pinch the metal clamp and pull the ink tube carefully to do so. Also keep in mind that some ink might be spilled while doing this, so use some wipes to rest the harness
upon. Next remove the 4 screws retaining the Print Head to the Harness with a small Philips screwdriver. They are indicated in the picture by . When all 4 screws are removed, you can disconnect the print head from the harness. Installation of the new print head happens in reverse order. Please make sure that the metal clamp pinches the ink line connector fi rmly on the new print head.
DPSn
otes
www.digiprint-supplies.com
The Ink Line Connector on the Xaar Print Head. The Metal Clamp securing the tube goes where indicated .
The backplate of the Xaar Print Head clearly indicates where the 4 screws retain it to the DGI Harness.
The data connector of the Xaar Print Head connects to the DGI Harness. It is a one-way fi t connector.