Design Review RSXS - EndStation
description
Transcript of Design Review RSXS - EndStation
Design ReviewRSXS - EndStation
Review on
Vacuum Chamber
Stand and Supports
Location
Beamline 8.0.1
Roll-up Endstation
All critical points coordinates shown on this drawing come from “ Jonathan Denlinger” spreadsheet with No. H22 and No. V11 updated: 11/19/07.
8.0 Critical Points Assy. Dwg. No. 26E828
• RSXS Endstation Assy.
• Beam left to right
• Height 92”- from casters to top of cryostat.
• Cryostat fully extended in 150mm
• Width with swivel casters - in beam direction 69” x 54”
• Beam is red
• Beam enter chamber at 5 degree
Chamber H = 28.5”
26” O.D. 25.62” I.D. .188” wall
• Width: flange to flange = 30” max.
• Weight: (335 lbs)
Chamber
• Entrance Flange 6” cf
• Exit Flange 12” cf
• Top Flange 8” cf
• Bottom Flange Rect. Opening 17” x 14”
Chamber Support Plate
• Support Height = 5.0” • Plate Thickness = 1.25”• Width = 38” x 38”• Through I.D. = 23” x 19.5”• Weight = 345 lbs.• Strut Tap = ¾-10 unc• Lifting Eye Tap = ¾-10 unc• Material = Steel
• Stand: • H = 28” • Width:
In beam direction 53”x47”
• Material:
Steel
• Weight: (345 lbs)
Moving & SupportOverall Estimated Weight: 2,450 lbs.
MovingLow Profile Swivel
Leveling Casters
Recommended Load Capacity with
4 Casters
7,920 lbs
SupportSwivel Leveling Pads
¾-10 unc Threaded Rod with Flange Nut and Spacer Washer
Pad Load=7,400 lbs ea.
6 Struts Support3/4” – Turnbuckle4 struts – 11” long2 struts – 18” long
Radial static load capacity:Rod End = 10,000 lbs.
All 6 Struts are Motorize
Vertical SlideModified version of Tom Miller’s, slide on
Beamline 4.0.3, from (ALM)American Linear Manufacturers
Some of the new spec.:-2” of stroke-47mm O.D. angle contact bearing = load
3150 lbs. max.-1” O.D. roller ballscrew .250 lead = load
3250 lbs. max.-custom steel motor end plate for larger dia.
Bearings and screw. -new strut mounting plate with two new
tapper holes for screws to be used as hard stop.
Horizontal Slide
The same slide used on BL 4.0.3 M301 mirror system from (ALM)
American Linear Manufacturers
ALM part: #11370-01-SPA
Some of the spec.:-2” of stroke
-.236 series crossed roller bearing
-Precision rolled leadscrew with anti-backlash leadscrew nut
-Nema 23 series frame motor mount and flex coupling
-Photo optical limit switches
Horizontal Slide
Assembly