DESIGN INTENT & SPECIFICATIONS FOR EXTERIOR SIGNAGE
Transcript of DESIGN INTENT & SPECIFICATIONS FOR EXTERIOR SIGNAGE
NOTES
GENERAL NOTES! Mounting conditions may vary per location. Refer to sign location plans for correct placement and orientation. Refer to the elevation view on this drawing for typical above finished floor / grade to the bottom of the sign dimension, or other mounting dimensions / restrictions (if applicable).!The general sign type detailing / dimensions shown here are for design intent purposes only and should not be used for actual fabrication purposes.!Final sizing for all structural members and attachment methods (i.e. connection bolts, anchors, reinforcement, etc) to be sized and approved by a licensed engineer to meet or exceed all applicable local, state, and national codes.!Transformers and electrical work (if applicable) to meet or exceed U.L. 2161 and all other applicable local, state, and national codes.
SIGN No. Type DescriptionSheet No. / Area New or Existing Sign Placement Remarks
SIGN No. Type DescriptionSheet No. / Area New or Existing Sign Placement Remarks
SIGN No. Type DescriptionSheet No. / Area New or Existing Sign Placement Remarks
Fax: 617.225.0216
These documents are intended to illustrate design intent and should only be used as a general guideline. No information contained here should be construed as engineered elements. The fabricator/contractor shall be responsible for all structural, electrical, mechanical and foundation engineering and specifications. Information and illustrations contained here are part of an original unpublished design by Carter & Burgess, Inc. Detailing and information contained on these pages shall not be reproduced, copied, or utilized except for the specific project for which they were created, without previous written authorization from Carter & Burgess, Inc.
© 2006 by Carter & Burgess, Inc.
# description
Revisions
date byAspen AirportWayfinding & Signage Program
Design Intent Specifications for Exterior Signage707 17th Street, Suite 2300Denver, CO 80202Phone: 303.820.5240Fax: 303.595.0833
101 N. 1st. Ave, Suite 3100Phoenix, AZ 85003Phone: 602.253.1200Fax: 602.253.1202
www.c-b.com
900 Circle 75 Pkwy, Suite 1100Atlanta, GA 30339Phone: 770.951.0020Fax: 770.951.0320
465 Medford StreetSuite 300Charlestown, MA 02129 Phone: 617.225.0200
Environmental Graphic Design Group
drawn by:
checked by:
scale:
project #:
UL, CN
BS
07156.106.3.1000orig. final submittal date: TBD sheet #:
sheet title
Red = Directional Sign
Sign Identifiers:Sign Location & Orientation:*
Green = Identification Sign
Blue = Informational Sign
N
LEGEND:
Level (Floor)
Sign Number
Sign Type
Airport Area Designation:T = TerminalCS = CurbsideGT = Ground TransportationP = ParkingR = Roadway
ST-000L1-000
TSign Location Marker
Side IndicatorA
B
*Note: Sign Location Markers are color-coded, please plot in color for best results
Gv ion
ener ATo al iat
F AAand
Rental Cars
Buses
GroundTransportation
Parking A
Terminal
Parking B
B
B
B
B
B
B
A
A
A
A
A
A
A
A
A
A
A
B
B
B
B
B
B
B
B
B
B
B B
ST-151
L1-027T
ST-201
ST-201
L1-061
L1-062
CS
CS
ST-201
L1-029CS
ST-201
L1-063CS
ST-252
L1-028GT
ST-151
L1-002T
ST-151
L1-001T
ST-252
L1-030GT
ST-201
L1-031CS
ST-201
L1-034CS
ST-251
L1-036CS
ST-201
L1-035CS
ST-201
L1-037CS
ST-201
L1-038CS
ST-251
L1-044CS
ST-201
L1-043CS
ST-201
L1-045CS
AST-401
L1-051R
hw 82g ay
Hi
rt ro e dAi
n g rpo F ta R .B
B
BB
B
B
B
B
B
B
B
B
B
B
B
B
B
B
A
A
A
A
AA
A
A
A
A
A
A
A
A
A
ST-401L1-054
R
ST-382L1-040
P
ST-252L1-057
GT
ST-401L1-056
R
ST-401L1-055
R
ST-252L1-058
GT
ST-201L1-059
CS
ST-201L1-032
CS
ST-401L1-060
R
ST-382L1-042
P
ST-351L1-053
P
ST-381L1-052
P
ST-351L1-049
P
ST-401L1-050
R
ST-201L1-033
CSST-201
L1-039CS
ST-201L1-041
CS
ST-201L1-046
CS
ST-382L1-048
PST-201
L1-047CS
Sign Location PlanSurvey Area A
06.02
NOTES
GENERAL NOTES! Mounting conditions may vary per location. Refer to sign location plans for correct placement and orientation. Refer to the elevation view on this drawing for typical above finished floor / grade to the bottom of the sign dimension, or other mounting dimensions / restrictions (if applicable).!The general sign type detailing / dimensions shown here are for design intent purposes only and should not be used for actual fabrication purposes.!Final sizing for all structural members and attachment methods (i.e. connection bolts, anchors, reinforcement, etc) to be sized and approved by a licensed engineer to meet or exceed all applicable local, state, and national codes.!Transformers and electrical work (if applicable) to meet or exceed U.L. 2161 and all other applicable local, state, and national codes.
SIGN No. Type DescriptionSheet No. / Area New or Existing Sign Placement Remarks
SIGN No. Type DescriptionSheet No. / Area New or Existing Sign Placement Remarks
SIGN No. Type DescriptionSheet No. / Area New or Existing Sign Placement Remarks
Fax: 617.225.0216
These documents are intended to illustrate design intent and should only be used as a general guideline. No information contained here should be construed as engineered elements. The fabricator/contractor shall be responsible for all structural, electrical, mechanical and foundation engineering and specifications. Information and illustrations contained here are part of an original unpublished design by Carter & Burgess, Inc. Detailing and information contained on these pages shall not be reproduced, copied, or utilized except for the specific project for which they were created, without previous written authorization from Carter & Burgess, Inc.
© 2006 by Carter & Burgess, Inc.
# description
Revisions
date byAspen AirportWayfinding & Signage Program
Design Intent Specifications for Exterior Signage707 17th Street, Suite 2300Denver, CO 80202Phone: 303.820.5240Fax: 303.595.0833
101 N. 1st. Ave, Suite 3100Phoenix, AZ 85003Phone: 602.253.1200Fax: 602.253.1202
www.c-b.com
900 Circle 75 Pkwy, Suite 1100Atlanta, GA 30339Phone: 770.951.0020Fax: 770.951.0320
465 Medford StreetSuite 300Charlestown, MA 02129 Phone: 617.225.0200
Environmental Graphic Design Group
drawn by:
checked by:
scale:
project #:
UL, CN
BS
07156.106.3.1000orig. final submittal date: TBD sheet #:
sheet title
Red = Directional Sign
Sign Identifiers:Sign Location & Orientation:*
Green = Identification Sign
Blue = Informational Sign
N
LEGEND:
Level (Floor)
Sign Number
Sign Type
Airport Area Designation:T = TerminalCS = CurbsideGT = Ground TransportationP = ParkingR = Roadway
ST-000L1-000
TSign Location Marker
Side IndicatorA
B
*Note: Sign Location Markers are color-coded, please plot in color for best results
Long-Term Parking
Rental CarStorage
Rental CarStorage
Car Wash
Employee Parking
H aigh 2w y 8
r rr F n agepo t o t RAi d.
B
A
B
ST-401L1-064
RST-401L1-065
R
ST-401L1-066
R
BA
ST-252
L1-070P
A
AA
B
BB
ST-201
L1-067CS
ST-201
L1-068CSST-382
L1-069P
06.03
Sign Location PlanSurvey Area B