DESIGN AND FABRICATION OF FIRE FIGHTING ROBOT SUBMITTED BY, M.Mohamed Hussain(80107144026)...
-
Upload
shauna-russell -
Category
Documents
-
view
214 -
download
1
Transcript of DESIGN AND FABRICATION OF FIRE FIGHTING ROBOT SUBMITTED BY, M.Mohamed Hussain(80107144026)...
DESIGN AND FABRICATION OF FIRE FIGHTING ROBOT
SUBMITTED BY,M.Mohamed Hussain(80107144026)P.Saravana Babu
(80107144040)L.H.Mohamed Shifa (80107144502)R.Prabhaharan
(80107144503)
PROJECT GUIDE,Mr.A.Balaji M.EAsst.Professor.,(Senior Grade)
PROBLEM:
Now a days if any fire accidents happens in Power
plants,Buildings,etc., the time and consumption of
human power is high.So there may be a possibility
of Heavy damage to human beings.
In order to save the human life by reducing time
and consumption,we are making the FFR(Fire
Fighting Robot).
ABSTRACT:
The basic Aim behind the project is to diffuse the
fire on dangerous terrain of a Power plant, Chemical units,
Atomic hazadarous area and others with the RF Remote
Controlled wireless Monitored Fire Fighting Mobile
Robot.
COMPONENTS:
Robot Vehicle (Sheet Metal)Wireless CameraRF Transmitter and Receiver89c51 Micro controller Control CircuitDC MotorWater TankGearCRT Monitor
DC Motor-12v:
It is used to drive the vehicle in forward and backward direction.This motor is also used to
operate the gears for rotate the arms at the top of the vehicle.
Battery:
In our project we are using 12v-5Amps lead acid battery,It continously works upto 3hoursTank:
In our Project we use water as the medium to extinguish the fire.2litre water tank is located at the
top of the vehicle .
89c51 MP:
The 89C51 is a low-power, high-performance microcomputer Flash
Programmable and Erasable Read Only Memory (PEROM).
Wireless Camera:
It is used to take photographs of environment which is then
transmitted to TV by means of RF controller.Gear:(Bevel Gear)
Bevel gears are gears where the axes of the two shafts intersect
and the tooth-bearing faces of the gears themselves are conically
shaped. Bevel gears are most often mounted on shafts that are 90
degrees apart, but can be designed to work at other angles as well. The
pitch surface of bevel gears is a cone.
433.92 RF Transmitter and Receiver : It is used to operate the Vehicle by means of Wireless operation with the help of Microprocessor circuit and it controls over 50 feet.
DIAGRAM:
DESIGN:
PHOTOGRAPH:
PHOTOGRAPH:
CIRCUIT-RF:
ADVANTAGE:Reduce Man Power.It Plays a vital role in electrical Fire Accident.Saves the Human life.
TIME REQUIRED:
Two more days required to finish the project.
THANK YOU