Data Sheet of DENSO Feu Tape
-
Upload
dnageshm4n244 -
Category
Documents
-
view
38 -
download
7
description
Transcript of Data Sheet of DENSO Feu Tape
Product Information
Special advantages
• permanently plastic
• conformable
• impermeable
• electrically insulating
• temperature resistant
DENSO®-FEU TapePetrolatum tape for sealing and corrosion protection of metallic components, pipes and fittings exposed to
continuous operating temperatures of -40 up to +70°C.
Description
Permanently plastic tape based on a
non-woven stitch-bonded PP-fleece.
The fabric is impregnated and
coated with a sealing and corrosion
protecting petrolatum compound.
Modification by polymers stabilises
the petrolatum compound and allows
operating temperatures of -40 up to
+70°C in areas where low
mechanical stresses are to be
expected. The tape is impermeable
to moisture and resistant against
aqueous solutions from electrolytes.
Use
• Corrosion protection of pipelines,
pipeline components, pipe
connections and fittings in
buildings and above-ground
installations
• Corrosion protection of structural
metallic components in buildings
and above-ground installations
• Corrosion protection of metallic
components or pipe systems
installed in concrete or floor
screed
• Galvanic separation layers of
metallic structures
• Sealing of heat insulating sheet
metal casings on cold or hot
pipelines and structural
components
• Sealing of industrial roof glazing
and green houses
DENSO GmbHP.O.Box 150120 • 51344 Leverkusen • Germany
tel: +49-(0)214-2602-0 • fax: +49-(0)214-2602-318
www.denso.de • [email protected]
Our literature, data sheets and recommendations
represent our best knowledge at the time of printing
but are in no way legally binding on us. Values and
properties shown in diagrams and tables are
typical properties, which are not subject to any
guarantee. Our liability is limited as per our
standard terms and conditions of sale.
No 04 issue: 07/08 DENSO-FEU
Properties
Property Unit Typical value
Thickness mm ≥ 1,0
Carrier - Polypropylene/Polyester-fleece
Drip point °C app. 100
UV stability - good
Specific electrical insulation resistance Ω ⋅ m2
106
Continuous operating temperature °C -40 bis +70
Application
The surfaces to be protected or
sealed have to be thoroughly
cleaned. Carefully remove rust, dirt,
foreign matter (e.g. oil, grease, old
insulation, weld splatter), moisture
and ice from the metal surface.
Apply at least one layer of DENSO-
FEU Tape for sealing and at least
two layers for corrosion protection.
DENSO-FEU Tape must be applied
with an overlap when wrapped on a
pipe or laid flat on the substrate.
Apply the tape with even tension
when wrapping spirally or apply
pressure when applying to flat
surfaces. Smooth the tape by hand
in the overlap area.
Application temperaturesAmbient +5 up to +50°C
Pipe surface +5 up to +50°C
DENSO-FEU Tape +10 up to +35°C
Storage temperature 0 up to +35°C
Packaging
standard
width
[mm]
rolls per
carton
lin. m
per carton
m²
per carton
weight per
carton
app. [kg]20 40 400 8,0 9,0
30 36 360 10,8 12,0
50 24 240 12,0 13,2
60 18 180 10,8 12,0
100 12 120 12,0 13,2
200 6 60 12,0 13,2
DENSO-FEU Tape
supplied as rolls
roll length 10 m