D 1.3 RAW WATER INpumps-DS-A-C Tce Hzl Bhel
-
Upload
shameer-majeed -
Category
Documents
-
view
7 -
download
0
description
Transcript of D 1.3 RAW WATER INpumps-DS-A-C Tce Hzl Bhel
SL.
EXHIBIT A- TECHNICAL SPECIFICATIONSECTION D1.3 DS A RW In P
DATA SHEET A SHEET 1 OF 3
RAW WATER INTAKE PUMPS
SL.NO. ITEM UNITSVALUES
1Total No. of pumps
Nos.3 x 50%
2No. of pumps operatingNos.
2
3Pump capacity m(/hrBy Contractor
4Pump Total Head
excluding losses in the pump
mBy Contractor
5Pump speed (max.) rpmBy Contractor (to limit specific speed to 6000 & ensure adequate NPSH at all conditions)
6Type of pumpVertical mixed flow
7
Type of internal element
Non pull out
8Liquid handled
River water
9Type of line bearing lubricationSelf
10Liquid for lubrication Pumped liquid
11Type of pump motor couplingFlexible
12Thrust bearing locationIn pump and motor
13Pump operating rangeRefer Note-1
14Motor ratingMinimum 116% of duty point requirement and also to meet the maximum power requirement over the operating range at 52.5 Hz frequency.
15Materials of construction
(a) Pump column pipeFab steel to IS:2062 with epoxy painting
(b) Pump bowl and discharge
elbowCI to IS:210 FG 260
(c) ImpellerSS 304 / BRONZE IS:318 Gr 2.
(d) Shaft SS 410
(e) Line shaft couplingSS 410
(f) Line shaft bearingCutlass rubber in SS shell
(g) All hardware under waterSS 304
(h) Sole plateMS to IS 2062
(i) Base plateCI/MS
(j) Shaft sleeveSS
1.6Inspection RequirementAs per relevant section
1)Note :
Pumps shall be capable of operating from shut-off point to a maximum flow of 10% over the point of intersection between system resistance curve and pump HQ curve for single pump operation.
2) Contractor shall establish the water levels in the reservoir and accordingly design the head of raw water pumps
_941359151.bin
_1100523862.doc