CUTTING SOFTWARE INSTALLATION

STEP 1: Insert the SignBlazer Elements disc into your computer. The disc is located in the accessoriesbox (small cardboard box).

IMPORTANT: If this disc is missing, SignBlazer Elements is available for download.

* * * * DOWNLOAD REQUIRED SOFTWARE * * * *

* * * * * * * * * * * * * * * * * * * * * * * * * * * *

STEP 2: The following screen will display when using the CD, select Run Autorun.exe.

STEP 3: Select Run Setup.

STEP 4: The Welcome to the SignBlazer setup screen will display, press Next.

STEP 5: Select Yes and press Next.

STEP 6: Select I accept the agreement and press Next (x6).

STEP 7: Select your cutter from the list. If your cutter is not listed, select the Copam CP-2500 andpress Next.

STEP 8: Select the COM? (if known) and press Next. If the cutter’s COM number is unknown selectCOM1.

STEP 9: Leave Baud Rate as 9600 and press Next.

STEP 10: Leave all this settings as shown and press Next.

STEP 11: Press Install.

NOTE: Installing...

STEP 12: Press Finish.

CUTTER SETUP

STEP 14: Press the Cutter and Setup buttons.

STEP 13: Open SignBlazer Elements, and press the Trial Mode button.

STEP 16: To cut press the Cutter and CUT! buttons, a window will open on the right side and press theCut Tile button.

STEP 17: If you need more information about SignBlazer, download the User's Manual.

Enjoy your new vinyl cutter! Thank you forchoosing USCutter

STEP 15: Select the Cutter and Output Device matching the settings from the example below.