CRD 9726 TNS - Opticon USAftp.opticonusa.com/...TNS_SpecManual_en-US-Letter.pdf · CRD 9726 TNS...
Transcript of CRD 9726 TNS - Opticon USAftp.opticonusa.com/...TNS_SpecManual_en-US-Letter.pdf · CRD 9726 TNS...
CRD 9726 TNS Modem Cradle
Specifications Manual
Opticon CRD 9726 TNS
Specifications Manual
2
All information subject to change without notice.
Document History Model Number: CRD 9726 Specification Number: CS06170
Edition: 1 Original Spec Number: CSO6169
Date: 2006-12-11
Copyright 2006 Opticon. All rights reserved. This manual may not, in whole or in part, be copied, photocopied, reproduced, translated or converted to any electronic or machine readable form without prior written consent of Opticon.
Limited Warranty and Disclaimers PLEASE READ THIS MANUAL CAREFULLY BEFORE INSTALLING OR USING THE PRODUCT.
Serial Number A serial number appears on all Opticon products. This official registration number is directly related to the device purchased. Do not remove the serial number from your Opticon device. Removing the serial number voids the warranty.
Warranty This Opticon product is warranted against defects in materials and workmanship as agreed in a written contract. Opticon will repair or, at its option, replace products that are defective in materials or workmanship with proper use during the warranty period. Opticon is not liable for damages caused by modifications made by a customer. In such cases, standard repair charges will apply. If a product is returned under warranty and no defect is found, standard repair charges will apply. Opticon assumes no liability for any direct, indirect, consequential or incidental damages arising out of use or inability to use both the hardware and software, even if Opticon has been informed about the possibility of such damages.
Packaging The packing materials are recyclable. We recommend that you save all packing material to use should you need to transport your scanner or send it for service. Damage caused by improper packaging during shipment is not covered by the warranty.
Trademarks Trademarks used are the property of their respective owners.
Opticon Inc. and Opticon Sensors Europe B.V. are wholly owned subsidiaries of OPTOELECTRONICS Co., Ltd., 5-3, Tsukagoshi 5-chome, Warabi-shi, Saitama, Japan 335-0002. TEL +81-(0) 48-446-1183; FAX +81-(0) 48-446-1180
SUPPORT USA Europe
Phone: 800-636-0090
Email: [email protected] Email: [email protected]
Web: www.opticonusa.com Web: www.opticon.com
Opticon CRD 9726 TNS
Specifications Manual
3
Contents 1. Abstract ................................................................................................................................... 5 2. Overview.................................................................................................................................. 5 3. Physical Features ................................................................................................................... 6
3.1. Dimensions...................................................................................................................... 6 3.2. Weight ............................................................................................................................. 6
4. Detailed View........................................................................................................................... 7 5. Basic Specifications............................................................................................................... 8
5.1. Cradle Specifications....................................................................................................... 8 5.2. Cable Interface ................................................................................................................ 8
6. Environmental Specifications ............................................................................................... 8 6.1. Operating Temperature and Humidity ............................................................................. 8 6.2. Storage Temperature and Humidity ................................................................................ 8
7. IrDA Configuration.................................................................................................................. 9 7.1. DIPSW Baud Rate Settings............................................................................................. 9 7.2. DIPSW Configuration ...................................................................................................... 9
8. LED Indicator .......................................................................................................................... 9 9. Durability ............................................................................................................................... 10
9.1. Shock ............................................................................................................................ 10 9.2. Static Electricity ............................................................................................................. 10
10. Reliability............................................................................................................................... 10 11. Serial Number ....................................................................................................................... 11 12. Packaging Specifications .................................................................................................... 12
12.1. Single Packing Specification ......................................................................................... 12 12.2. Collective Packing Specification.................................................................................... 13
13. Regulatory Compliance........................................................................................................ 13 13.1. EMC .............................................................................................................................. 13 13.2. Product Safety............................................................................................................... 13 13.3. Other ............................................................................................................................. 13 13.4. Compliance to RoHS..................................................................................................... 13
14. Safety ..................................................................................................................................... 14 14.1. Shock ............................................................................................................................ 14 14.2. Temperature Conditions................................................................................................ 14 14.3. Foreign Materials........................................................................................................... 14
Opticon CRD 9726 TNS
Specifications Manual
4
14.4. Installation ......................................................................................................................14 14.5. Other ..............................................................................................................................14
Table of Figures Figure 1: Setup ............................................................................................................................5 Figure 2: Dimensions ...................................................................................................................6 Figure 3: Detailed view ................................................................................................................7 Figure 4: Baud rate settings.........................................................................................................9 Figure 5: Serial number label.....................................................................................................11 Figure 6: Single packaging ........................................................................................................12
Opticon CRD 9726 TNS
Specifications Manual
5
1. Abstract This manual provides specifications for the CRD 9726 modem cradle.
2. Overview The CRD 9726 is a modem cradle designed for the OPL 9728 data collector.
Data stored in the OPL 9728 data collector can be transmitted via a modular cable when the data collector is set in the CRD 9726 cradle.
Figure 1: Data transmission via modular cradle
Opticon CRD 9726 TNS
Specifications Manual
6
3. Physical Features 3.1. Dimensions
W 71.5 x D 98.5 x H 67.5 mm
Figure 2: Dimensions
3.2. Weight 75 g (excluding the cable and AC adaptor)
Opticon CRD 9726 TNS
Specifications Manual
7
4. Detailed View
Figure 3: Detailed view
No. Name Function
1 DC power connector DC power connector for AC adapter
2 Modular jack Connects to the telephone cable
3 IrDA transmission window Communicates with the data decoder (OPL 9728)
4 Power LED (red) LED appears red when the power is ON
5 Receiving LED (green) LED appears green when receiving via IrDA
6 Sending LED (yellow) LED appears yellow when sending via IrDA
7 Transmission settings switch Used to set IrDA transmission speed
8 Serial label
9 Power supply terminal (+) Data collector power supply terminal (+) side
10 Power supply terminal (-) Data collector power supply terminal (-) side
Opticon CRD 9726 TNS
Specifications Manual
8
5. Basic Specifications 5.1. Cradle Specifications
Item Name Specifications Remarks
Display LED Power: red Transmitting data: green/orange
Center Left/right
Waterproofing N/A
Power Supply Main power AC adapter: 5.7V/550mA
5.2. Cable Interface
Item Name Specifications Remarks
Line used Telephone line
Line voltage 48 V
Communications protocol ITU-T V.90, V.34,V.32 bis, V.32, V22bis, V.22, V.23, Bell 212A, V.21, Bell 103
Selectable
Data compression method ITU-T V.42 bis, MNP5 Selectable
Error correction method ITU-T V.42, MNP2-4 Selectable
Transmission speed 9,600 bps - 56,000 bps Depends on communication protocol
Modulation method PCM, TCM, QAM Depends on communication protocol
Dialing PULSE: 10/20 pps, DTMF Selectable
Modem control command AT command Refer to Si2457 specifications for details
Interface
Line connector RJ-11 6P modular connector
6. Environmental Specifications 6.1. Operating Temperature and Humidity
Temperature: 0 to 40 °C
Humidity: 25 to 85%
6.2. Storage Temperature and Humidity Temperature: -20 to 60 °C
Humidity: 20 to 90%
Opticon CRD 9726 TNS
Specifications Manual
9
7. IrDA Configuration Transmission settings can be adjusted via the transmission settings switch on the bottom of the device.
7.1. DIPSW Baud Rate Settings SW1-SW6 baud rates can be set as indicated in the following table.
7.2. DIPSW Configuration
DIPSW Baud Rate
SW1 SW2 SW3 SW4 SW5 SW6
115.2Kbps ON ON ON X X OFF
57.6Kbps OFF ON ON X X OFF
38.4Kbps ON OFF ON X X OFF
19.2Kbps OFF OFF ON X X OFF
9.6Kbps ON ON OFF X X OFF
4.8Kbps OFF ON OFF X X OFF
2.4Kbps ON OFF OFF X X OFF
Remove the switch cover to adjust the settings.
Replace the cover after you have finished adjusting the settings.
Figure 4: Baud rate settings
8. LED Indicator The cradle uses three types of LEDs to indicate its status.
LED Color Indications
Power LED Red Main battery is on
Green Sending data Transmission LED
Orange Receiving data
Opticon CRD 9726 TNS
Specifications Manual
10
9. Durability 9.1. Shock
There was no sign of malfunction with the scanner’s structural performance after the following drop test.
• Drop Test: Drop the scanner from 75 centimeters above a concrete surface, once in each of 6 directions.
9.2. Static Electricity
Item Specifications Remarks
Static electricity Aerial discharge ± 8kV No malfunction
Aerial discharge ± 15kV No destruction
Contact discharge ± 8kV No malfunction
10. Reliability Mean Time Between Failures (MTBF): 10.1 years.
Opticon CRD 9726 TNS
Specifications Manual
11
11. Serial Number The CRD 9726 displays the following serial number label.
Figure 5: Serial number label
Opticon CRD 9726 TNS
Specifications Manual
12
12. Packaging Specifications 12.1. Single Packing Specification
Put the CRD 9726 in a protective foam bag and place it in a single packing box alongside the accessories.
Size of the package (when assembled): W 165 x D 110 x H 82 mm
Figure 6: Single packaging
Opticon CRD 9726 TNS
Specifications Manual
13
12.2. Collective Packing Specification Please refer to the OPL9728 MODEM KIT specifications.
Note: The “RO” mark labeled on the package tray or package box guarantees that the applicable product has passed our test of RoHS restrictions compliance (the restriction of the use of certain hazardous substances in electrical and electronic equipment, 2002/95/EC). However, this document does not have any legal weight in the European Union.
13. Regulatory Compliance 13.1. EMC
EN55022
EN55024
FCC Part 15 Subpart B Class B: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
13.2. Product Safety EN60950-1
13.3. Other ES 203 021
ACTA TIA 968
Telecommunications Business Law – Japanese telecom testing according ordenance 31
13.4. Compliance to RoHS RoHS: The restriction of the use of certain hazardous substances in electrical and electronic equipment, 2002/95/EC
Opticon CRD 9726 TNS
Specifications Manual
14
14. Safety Handle this product carefully. Do not deliberately subject it to any of the following.
14.1. Shock • Do not subject the cradle to long-term vibration.
• Do not throw or drop the unit.
• Do not place heavy objects on the cradle.
• Do not squeeze the cradle between heavy items.
14.2. Temperature Conditions • Do not use the cradle at temperatures outside the specified range.
• Do not pour boiling water on the cradle.
• Do not place the cradle near a fire place.
14.3. Foreign Materials • Do not put the cradle into water.
• Do not put the cradle into chemicals.
14.4. Installation • Install this product on a dry and clean place.
• Place this product on a flat horizontal surface, like a table or shelf.
• Do not use the scanner near a radio or a TV receiver. It may cause reception problems.
14.5. Other • Do not disassemble this product.