Title: a concise and characteristic description of theinvolved research content

Family name First name1 and First name Middle name Family name2*

Received August 29, 2020

Accepted October 19, 2020

© Jilin University, The Editorial Department of Chemical Research in Chinese Universities and Springer-Verlag GmbH

Article

Article

Article

2 Chem. Res. Chinese Universities

https://doi.org/10.1007/s40242-020-00274-0

Chem. Res. Chinese Universities 2

https://doi.org/10.1007/s40242-021-0???-?

2 Chem. Res. Chinese Universities

https://doi.org/10.1007/s40242-021-0???-?

A

n abstract is a summary of the content of the manuscript. It should briefly describe the research purpose, method, results, and conclusion. Highly specialized terms, special signs, figures, tables, and equations should be avoided, and citation of references is not allowed.

Keywords Keyword1; Keyword2; Keyword3;…

1 Introduction

The introduction provides the relevant research background and the progress in the past 2–3 years with references cited in numerical order. It presents the problem to be solved, and then describes the method adopted in the work. The aim of the research and its significance should be indicated. Do not use subtitle in this part. The references cited in the main text should be like this[1], with no blank space between two serial numbers [2,3,4–6].

2 Experimental

2.1 XXXXXXXXXX

This part gives the materials, method, and experimental procedure of the work, so others may repeat the work.

2.1.1 XXXXXXXX

?????????????????????????

2.1.2 XXXXXX

?????????????????????????

2.2 XXXXXX

Family name First name

xxxxxx@xxxxxx

XXX Xeng

xxxxxxx@xxxxxxx

# These authors contributed equally to this work.

1. State Key Laboratory of Inorganic Synthesis & Preparative Chemistry, Jilin University, Changchun 130012, P. R. China;

2. Department of Chemistry, University of Tennessee, Knoxville, TN 37996, USA

?????????????????????????

3 Results and Discussion

Research results, including data and models, are presented and discussed in this section. Tables and figures may be used. Be complete but concise. Only the most significant and representative data should be included. Extended or supplemental results should appear as Supporting Information. Avoid irrelevant comparisons and speculations that are not supported by the results in the paper.

3.1 XXXXXX

?????????????????????????

3.1.1 XXXXX

?????????????????????????

3.1.2 XXXXX

?????????????????????????

Scheme 1 XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX

(1)

(2)

Table 1 xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

xxxxxx

Ma/(mol·L–1)

V b/cm3

Ref.

[2]

[8]

[11]

a. ; b. .

3.2 XXXXXXXXXXXXXXXXXXXX

?????????????????????????

3.2.1 XXXXXXXXXXXXXXX

?????????????????????????

3.2.2 XXXXXXXXXXX

????????????????????????

(A)

Fig.1 XXXXXXXXXXXXXXXXXXXXXXXX

(Note: The figures should have resolution not lower than 400 dpi (RGB)and clear lines of 3 px, with signs and letters in Times New Roman at 8 pt(JPG or TIF format). A space should always be maintained between the variable and the unit. The source files are strongly recommended to be uploaded as well as the main documents if there are vector graphics, such as *.org or *.opj files by Origin, *.cdr files by Coraldraw, *.cdx files by ChemDraw, *.ai files by Adobe Illustrator and *.psd files by Photoshop, etc.) The pictures are the same size, and the experiment points are the same size.Lines 0.5 to 0.75 pound, scale inward. Glyph: Regular/Italic, Bold,The length of the label line is 1.4mm, the label value is equally divided, the distance from the label line is 1.4mm, the physical quantity (Italic) is separated from the unit (Regular) oblique line, and the distance from the label value is 1.4mm.The diameter of the experimental point is 1.4mm;[(A), (B),......], multi-line annotation in single figure [a, b...].

4 Conclusions

Conclusions should be derived from the observation and results in the paper. Do not summarize information already presented in earlier sections.

Electronic Supplementary Material

Supplementary material is available in the online version of this article at http://dx.doi.org/10.1007/s40242-020-???-?.

Acknowledgements

This work was supported by the?????????(No.?????).

Availability of Data and Materials

All data generated or analyzed during this study are included in this published article and its supplementary information files.

Conflicts of Interest

The authors declare no conflicts of interest.

References

[1] (Example for Journal) Chae H. G., Kumar S., Science, 2008, 319, 908

[2] (Example for Books) Kelly A., Macmillan N. H., Strong Solids, Oxford University Press, New York, 1986

[3] (Example for Conference proceedings) Mangano C., Mangano F., Proceedings of the 2nd International Dental Conference on Future Trend in Implantology (FTI), Florence, Italy, 2011

[4] (Example for Dissertation)Liu G. X., Classification of finite dimensional basic Hopf algebras and related topics. Dissertation for the Doctoral Degree, Hangzhou University, Hangzhou, 2005, 24

[5] (Example for Patent) Zhang H. X., Wang J. J., Ma J., Zhuang H. L., Ao Y. H., Wang H. J., Zhou B. Q., Preparation of Polymer for Polyacrylonitrile-based Carbon Fiber Precursor, CN100564413, 2007

[6] (Example for User manual)Wang D. L., Zhu J., Li Z. K., User Manual for QTKMapper Version1.6, 1999

[7] (Example for Software)  Frisch M. J., Trucks G. W., Schlegel H. B., Scuseria G. E., Robb M. A., Cheeseman J. R., Scalmani G., Barone V., Mennucci B., Petersson G. A., Nakatsuji H., Caricato M., Li X., Hratchian HP, Izmaylov AF, Bloino J, Zheng. G, Sonnenberg JL, Hada M, Ehara M, Toyota K, Fukuda R., Hasegawa J., Ishida M., Nakajima T., Honda Y., Kitao O., Nakai H., Vreven T., Montgomery J. A., Jr, Peralta J. E., Ogliaro F., Bearpark M., Heyd J. J., Brothers E., Kudin K. N., Staroverov V.N., Kobayashi R., Normand J., Raghavachari K., Rendell A., Burant J. C., Iyengar S. S., Tomasi J., Cossi M., Rega N., Millam J. M., Klene M., Knox J. E., Cross J. B., Bakken V., Adamo C., Jaramillo J., Gomperts R., Stratmann R. E., Yazyev O., Austin A. J., Cammi R., Pomelli C., Ochterski J. W., Martin R. L., Morokuma K., Zakrzewski V. G., Voth G. A., Salvador P., Dannenberg J. J., Dapprich S., Daniels A.D., Farkas Ö., Foresman J. B., Ortiz J. V., Cioslowski J., Fox D. J., Gaussian 09 (Revision A.02), Gaussian, Inc., Wallingford CT, 2009

[8] (Example for Website) http://www.ccin.com.cn/ccin/news/2011/06/07/ 182521.shtml, accessed on 2011-09-26

[9] Chen W., Gao C., Liu X., Liu F., Wang F., Tang L. J., Jiang J. H., Anal. Chem., 2018, 90, 8736

[10] Tong H., Hong Y., Dong Y., Haeussler M., Li Z., Lam J. W. Y., Dong Y., Sung H. H., Williams I. D., J. Phys. Chem. B, 2007, 111, 11817

[11] Ding D., Li K., Liu B., Tang B. Z., Acc. Chem. Res., 2013, 46, 2441

Article

D2

0

(1/)()

ijijijijij

Frrnvn

g

=--×

222

122331

sp

4

()()()

2

g

R

llllll

a

-+-+-

=