Corner Plant Holder

Project: Corner Plant Holder of 16

Corner Plant Holder

I think there is no home without at least few beautiful plants enriching a living space. They look especially beautiful if put together on one place. If you provide them good care, they will grow and blossom, but also take more and more of your space each year. And this wooden Corner Plant Holder is just a perfect solution. You can put several flower pots on it – even the biggest ones – put it in the corner and simple enjoy it.

Carefully make the items by following the measurements given on particular pictures. The measurements are given in millimeters, while the measurements given in inches are in brakes (1 inch = 25, 4 mm). You can use various types of wood, but we recommend birch, cedar, beech, maple or alder.

Project from WWW.CRAFTSMANSPACE.COM

http://www.craftsmanspace.com

Project: Corner Plant Holder of 16 Parts list



Project: Corner Plant Holder of 16 Assembly drawing




Standard Parts




Assemblage Instructions:

1. Screw the Dowel Screws D5x70mm (part 8) into the holes made on the Legs (part 5). This way made subassemblies pull throuhg the holes on the Board 4 (part 1). Screw two Covers (part 6) on the Dowel

Screws D5x70mm (part 8), just like on the picture.




2. Pull Woodscrews D5x45mm (part 9) through the remaining two holes on the Board 4 (part 1) and screw the Columns (part 7) on it. Don not forget to put the Washers D5 mm (part 10) under the woodscrew caps.




3. Screw the Dowel Screws D5x70mm (part 8) on the top of Columns (part 7).

4. Put the Board 3 (part 2) on his place and screw the Covers (part 6) on thier places.




5. Pull Wood screws D5x45mm (part 9) through the remaining two holes on the Board 3 (part 2) and screw Columns (part 7) on it. Do not forget to put the Washers D5 mm (part 10) under the woodscrew caps.




Repeat the same procedure for the remaining parts.



Corner Plant Holder

Documents

Transcript of Corner Plant Holder