Connecting PEMF Coil to the XM Generator

Spooky2 Connecting PEMF Coil to the XM G

enerator

Our Users & Team

Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com

Email:[email protected] [email protected]

The PEMF Coil connects directly to OUT1 of your XM generator using the

BNC to 6.3mm Mono adapter specially designed by Spooky2.



For greater power, the PEMF Coil can also be connected to Spooky Boost c

able using the same BNC to 6.3mm Mono adapter.

Red to red, blue to blue gives the correct magnetic polarity when Out 1 is +1

00% offset and Out 2 is -100% offset.



The PEMF Coil can also connect to OUT1 of Spooky Boost v2.0. The signa

l strength is not as strong as using the Spooky Boost cable but it is adequat

e for low power applications.

The Colloidal Silver output port on Spooky Boost v2.0 is not recommended

for use with the PEMF coil. The signal will be too weak.



You can connect PEMF coil with the MN port of Spooky Boost v2.0. The ad

apter will require the BNC straight female to female connector.



Thank you!

Connecting PEMF Coil to the XM Generator

Health & Medicine

Transcript of Connecting PEMF Coil to the XM Generator