Connecting devices / trainers in TTS 4.12.1 Select Setup ... · Connecting devices / trainers in...
Transcript of Connecting devices / trainers in TTS 4.12.1 Select Setup ... · Connecting devices / trainers in...
When you see NO ANT USB STICk connected then that is NOT a problem for i-Flow or Fortius users.
You do not need this. Just press SCAN. The select one by one the Trainer
If you have an i-Genius – Vortex or Bushido trainer, then you need to plug in your USB antenna
Now SELECT the Device (the picture) with your mouse.
Then the button CONNECT will highlight. Now press connect
For the Genius the Steering Calibration will appear. Follow the procedure
After this, connect the other Devices
With the Genius the ALIGNMENT is not needed. If you do this, make sure that the tire is not
connected to the roller.
When everything is connected, the stat buttons will be highlighter
FORTIUS AND FLOW USERS – connecting analogue heartrate belts
You need to follow the same connection process, with your heart rate belt on. It is important that
you are close to your T1932 or T1942 interface so that the analogue signal can be received by the
head unit. Then it will appear in the software and you can connect.
Use also USB2 port. This will not cause any disconnect events.