Computer Networking Error Control Coding
description
Transcript of Computer Networking Error Control Coding
Computer NetworkingError Control Coding
Dr Sandra I. Woolley
An Introduction to Error Control Coding Data transmission and channel
errors Introduction to error control Parity Hamming codes
– example of a simple linear block code
Interleaving and product codes – (+ demonstration).
IP checksums (Polynomial/Cyclic Redundancy Codes)
We will work through examples in class.
http://www.thinkgeek.com/interests/exclusives/7a5c/images/1293/
3
Introduction Error control coding involves the addition of redundancy to
enable error detection and/or correction.
There are two basic approaches to error control– Automatic retransmission request (ARQ)– Forward error correction (FEC)
More generally, when errors are detected data can be resent, concealed or corrected.
4
Data Transmission
Compress
Data
Encrypt Error control Line code
Channel errors
Remove redundancy for efficient communication
Encrypt message for added security
Add systematic redundancy to protect data against channel errors
Encode signal to suit communication channel characteristics
..01110110....01101010..
5
Designing Error Protection Systems “Know your enemy”
– Understand the channel burst length distribution and gap length distribution, i.e., how large and how frequent are the errors.
Trade-off the correction of data with the addition of redundancy – System cost/delay
Should errors be detected and corrected? – Detect and request retransmission? Detect and conceal?
How important is the data. – Is all data equally important? Should some data elements be
protected more than others? Is accepting bad data as good worse than rejecting good data as
bad?
6
Channel Errors Errors can occur singly or in bursts. Most channel errors can be approximated by simple state models. The BER (Byte error rate) is a simple measure of channel quality.
In the Good state there are no errors. Bad Type 1 and Bad Type 2 represent two types of error events; non-
burst and burst. p1 and p2 are the probabilities of starting the errored states. q1 and q2 are the probabilities of ending the errored states.
GoodBad
Type 21-q2
p2
Bad Type 11-q1
p1 1-p1-p2
The modified Gilbert model
q1 q2
7
Channel Errors Burst length distributions provide important information about
channel error activity.
GoodBad
Type 21-q2
p2
Bad Type 11-q1
p1 1-p1-p2
increasing p1
decreasing q1
increasing p2
decreasing q2
error length (log scale)
Pro
babi
lity
(log
scal
e)
q1 q2
The Simplest Error Detection – Parity Bit Odd or even parity requires
that the sum total of codewords be odd or even, respectively.
So for odd parity there will be an odd number of ones and for even parity there will be an even number of ones.
For example, if we have data bits 0011010 and we want even parity. We need to add a parity bit of 1 to have an even number on ones. So, if we append our parity bit to the end, we have a codeword of 00110101 (where 1 is our even parity bit).
7 bits of data(number of 1s)
8 bits including parity
even odd
0000000 (0) 00000000 100000001010001 (3) 11010001 010100011101001 (4) 01101001 111010011111111 (7) 11111111 01111111
Examples from WikipediaThe parity bit is added to the front
http://en.wikipedia.org/wiki/Parity_bit
9
The Hamming (7,4) Code An example of an (n,k) linear block code. Each codeword contains n bits,
k information bits and (n-k) check bits. The Hamming (7,4) is a nice easy code but it is not very efficient (it has a
75% overhead!). It generates codewords with a ‘Hamming distance’ of 3, i.e., all codewords differ in 3 locations. It can correct one bit in error and detect two.
In the codeword [C]= k1 k2 k3 k4 c1 c2 c3, k1-k4 are information bits and c1-c3 are check bits (the ‘systematic redundancy’). “+” here denotes binary addition (it is the same as XOR).
c1=k1+k2+k4c2=k1+k3+k4c3=k2+k3+k4
So the data [X] = [0 1 1 0] becomes the codeword [0 1 1 0 (0+1+0) (0+1+0) (1+1+0)] = [0 1 1 0 1 1 0]
10
The Hamming (7,4) Code
If we insert an error at bit 2[ x ](syndrome)[0 1 1 0 1 1 0]becomes[0 0 1 0 1 1 0]
Note c1 and c3 are wrong - these intersect at k2 hence k2 is in error
c1=k1+k2+k4
c3=k2+k3+k4c2=k1+k3+k4
k1 k2
k4
k3
0
01
1
0
1
0
11
The Hamming (7,4) Code
If we insert an error at bit 4[ x ](syndrome)[0 1 1 0 1 1 0]becomes[0 1 1 1 1 1 0]
Note c1,c2 and c3 are all wronghence k4 is in error
c1=k1+k2+k4
c3=k2+k3+k4c2=k1+k3+k4
k1 k2
k4
k3
0
01
1
1
1
1
12
Bi-Directional/Product Codes Imagine we have 4 x 4 data bits k11-k14, k21-k24, k31-k34,
k41-k44
Arranging them horizontally we can add error protection in the vertical direction as well.
k11 k12 k13 k14 c11 c12 c13 k21 k22 k23 k24 c21 c22 c23 k31 k32 k33 k34 c31 c32 c33 k41 k42 k43 k44 c41 c42 c43 d11 d12 d13 d14 f11 f12 f13 d21 d22 d23 d24 f21 f22 f23 d31 d32 d33 d34 f31 f32 f33
13
Bi-Directional/Product Codes In the class we observe animated demonstrations of these codes
at work using the product code demonstrator. – First we generate errors using the Modified Gilbert Error
Model. The model requires just 4 probability values to describe the errors it generates.
– Next the data was interleaved.– Then the data was iteratively corrected vertically and
horizontally. The demonstration shows how, with more sophisticated error
control coding, we can significantly increase correction capacity making even severely corrupted data correctable.
The complex and time-consuming nature of this method makes it inappropriate for Internet protocols*. However, robust correction is desirable in storage systems and these methods can be found in the more sophisticated server room RAID-type** storage systems.
*but important payload data could be protected in this way**RAID – Redundant Array of Inexpensive Disks
14
InterleavingInterleaving (systematically reordering) the protected data stream means that errors are distributed, i.e., more correctable.
For example, consider the three (7,4) Hamming codewords below in transmission on a channel with a small burst of 3 errored bits (syndrome x x x).
k1 k2 k3 k4 c1 c2 c3 k1 k2 k3 k4 c1 c2 c3 k1 k2 k3 k4 c1 c2 c3 x x x These 3 bits all fall in one codeword, so would be uncorrectable.
But with a three-way interleave:-k1 k1 k1 k2 k2 k2 k3 k3 k3 k4 k4 k4 c1 c1 c1 c2 c2 c2 c3 c3 c3 x x x Assuming the same syndrome of 3 bits in error, if we unscamble the bits (shown below) we can see now there is now just one bit in error in each codeword, and so our data is correctable.k1 k2 k3 k4 c1 c2 c3 k1 k2 k3 k4 c1 c2 c3 k1 k2 k3 k4 c1 c2 c3 x x x
15
More Sophisticated Codes Sophisticated interleaving strategies are used in most advanced digital
recording systems. CDs use product codes but with Reed-Solomon codes (not Hamming.)
They also use interleaving. DVDs and Blu-ray discs also use Reed Solomon block codes.
Reed-Solomon (RS) codes work on groups (e.g., bytes) of inputs. For bytes n<28 (codewords are a maximum of 255 bytes). There is only a very small probability of ‘crypto-errors’, i.e., correcting good bytes by mistake.
RS block codes can correct (n-k)/2 bytes and detect (n-k) bytes. For example, RS(122,106) can correct (122-106)/2 = 8 bytes in error.
Other systems use layers of error correction. If a lower (simpler) layer detects errors, the next (more powerful) layer is inspected. If errors are still detected the final layer is interrogated. This method increases the speed of decoding by only computing check bytes when errors are suspected. DAT tape drives uses 3 layers of error control.
16
IP Checksum The IP checksum is an IP header field. It is calculated using the
contents of the header. It was designed for ease of implementation in software (rather
than its error-detection ability) because it has needed to be recalculated (IPv4) at every router.
Consider L 16-bit words making up the information bits (IP header).
Checksum, bL, is given by : bL=-x So that adding the 16-bit words and the checksum (as below)
gives 0.
(Assessment does not require worked examples. For interest only, this is a tutorial example of how the checksum is calculated with 1’s complement arithmetic is
http://www.netfor2.com/checksum.html )
)12(mod..... 16110 Lbbbx
)12(mod.....0 16110 LL bbbb
17
Polynomial/Cyclic Redundancy Check (CRC) Codes
k information bits (ik-1, ik-2, .... i1,i0) create an information polynomial i(x), of degree k-1.
i(x)=ik-1xk-1 + ik-2xk-2 + ... + i1x + i0
i(x) and a generator polynomial, g(x), are used to calculate a codeword polynomial, b(x).
Checksum calculation :Divide xn-ki(x) by g(x) to obtain the remainder r(x).xn-ki(x)=g(x).q(x) + r(x) (q(x)= quotient and r(x)=remainder)
b(x) = xn-ki(x) + r(x)
n bits k bits n-k bits
18
Binary Polynomial Division
Division with Decimal Numbers
32
35 ) 12223
10517 2
4
140divisor
quotient
remainder
dividend1222 = 34 x 35 + 32
dividend = quotient x divisor +remainder
Polynomial Divisionx3 + x + 1 ) x6 + x5
x6 + x4 + x3
x5 + x4 + x3
x5 + x3 + x2
x4 + x2
x4 + x2 + xx
= q(x) quotient
= r(x) remainder
divisordividend
+ x+ x2x3
Note: Degree of r(x) is less than degree of divisor
Transmitted codeword:b(x) = x6 + x5 + xb = (1,1,0,0,0,1,0)
1011 ) 1100000 1110
10111110101110101011
010
x3 + x + 1 ) x6 + x5
x3 + x2 + x
x6 + x4 + x3
x5 + x4 + x3
x5 + x3 + x2
x4 + x2
x4 + x2 + x
x
Polynomial Example: k = 4, n–k = 3
Generator polynomial: g(x)= x3 + x + 1Information: (1,1,0,0) i(x) = x3 + x2
Encoding: x3i(x) = x6 + x5
Examples of Standard Generator Polynomials
CRC-8:
CRC-16:
CCITT-16:
CCITT-32:
CRC = cyclic redundancy check
ISO HDLC, XMODEM, V.41, Bluetooth
IEEE 802, DoD, V.42, MPEG-2
IBM Bisync
ATM = x8 + x2 + x + 1
= x16 + x15 + x2 + 1= (x + 1)(x15 + x + 1)
= x16 + x12 + x5 + 1
= x32 + x26 + x23 + x22 + x16 + x12 + x11 + x10 + x8 +
x7 + x5 + x4 + x2 + x + 1
Thank You
Recommended private study exercise : read the error control coding section from Chapter 3 of the recommended text.
Use the content of the slides to guide your revision. Methods not referred to in the slides will not be assessed.