COLLAR - Applied Applications International

2
Speedi-Collar™ plastic take off collar has revolutionized the HVAC industry! Speedi-Collar was specifically designed to attach in seconds, eliminate installer injury and seal air tight. The Speedi-Collar Advantage INSTALLS FASTER - Pre-Install Flex or Metal Duct! REDUCES INJURY - No tabs to bend back. SEALS TIGHTER - Greatly minimize air/energy loss. 2-SIDED GASKET - Reduces extra sealant costs. GREEN building product. FIRE RATED for use in a plenum UL2043. • 157 times LESS CONDUCTIVE than metal. COST EFFECTIVE alternative. REPLACES tab AND stick-on metal collars. Speedi-Collar VS. Metal Duct Board Trunkline Sheet Metal Trunkline Pre-Install Flex Duct (for faster installation) Available in: 5”, 6”, 7”, 8”, 10” and 12” sizes dampered and damperless models. www.speediboot.com MADE IN U.S.A. • No sharp edges • Dent proof • Lightweight • Rust proof ONE COLLAR The Speedi-Collar can be used with 1”, 1-1/2”, 2” duct board and sheet metal trunk lines, and is sized for metal pipe and flexible ducting. C O LLAR

Transcript of COLLAR - Applied Applications International

Energy Efficient, Self-Sealing Start Collar

Speedi-Collar™ plastic take off collar has revolutionized the

HVAC industry! Speedi-Collar was specifically

designed to attach in seconds, eliminate installer injury

and seal air tight.

The Speedi-Collar Advantage• INSTALLS FASTER - Pre-Install Flex or Metal Duct!

• REDUCES INJURY - No tabs to bend back.

• SEALS TIGHTER - Greatly minimize air/energy loss.

• 2-SIDED GASKET - Reduces extra sealant costs.

• GREEN building product.

• FIRE RATED for use in a plenum UL2043.

• 157 times LESS CoNDUCTIvE than metal.

• CoST EFFECTIvE alternative.• REpLACES tab AND stick-on metal collars.

Speedi-Collar VS. Metal

Duct BoardTrunkline

Sheet Metal Trunkline

Pre-Install Flex Duct(for faster installation)

Available in: 5”, 6”, 7”, 8”, 10” and 12” sizes dampered and

damperless models.

www.speediboot.com

MADE IN U.S.A.

• No sharp edges

• Dent proof

• Lightweight

• Rust proof

oNE CoLLARThe Speedi-Collar can be used with 1”, 1-1/2”, 2” duct board and sheet metal trunk lines, and is sized for metal pipe and flexible ducting.

COLLAR

Speedi-Collar

Applied Applications Intl., Inc.500 Colorado St. • Kelso WA [email protected] • www.speediboot.com 1-866-794-7900

Contact us today!

FASTER INSTALLThe Speedi-Collar creates a faster connection to both ductboard and sheet metal trunk lines. The Speedi-Collar features a double sided adhesive gasket, Zip Clips and pre-drilled sheet metal screw holes for attachment in seconds!

STAY IN pLACE DAMpER The Speedi-Collar damper design features a ratchet system which locks the damper in six different positions and an internal lip for a tight close. The damper handle sets off from the collar and can be either covered by the flex duct or metal pipe or left exposed depending on your installation preferences.

FULL LINE

The take off collar is another component in the Speedi-Boot™ line for all of your residential, light commercial and retrofit needs. Other energy efficient products are currently in development and will be available in the near future.

GREEN BUILDING pRoDUCTSThe Speedi-Collar is the energy efficient and time saving alternative you’ve been waiting for greatly reducing air/energy loss while saving considerable installation time (based on method of sealing and installation). Current housing market inspection pro-cesses will reward tighter ducts with tax credits and energy-efficient trade-offs.

FIRE TESTED The Speedi-Collar is UL 2043 Classified. Both the UL and NFPA 90A documents have clarified the applicability of UL 2043 for discrete products used in the air handling space. Additionally NFPA 90A was revised to state that UL 2043 is to be used to assess “other discrete products” – not only loudspeakers and recessed lighting fixtures.

The updated scope states that UL 2043 is the alternate test method used when UL 723 (E-84 Steiner Tunnel 25/50 test) is not applicable and that this standard is no longer limited to just electrical products.

CoDE ACCEpTEDSpeedi-Collar’s are currently being installed across the U.S. and accepted by code in most markets. The authority having jurisdiction should be referenced to determine what law ordinance or code should apply when using the Speedi-Collar. The Speedi-Collar meets all minimum code requirements in its design.

Pre-attach Speedi-Collar to your flex and

climb the ladder once!

MFT CODE DESCRIPTION YOUR PRICE

SC-05 5” COLLAR

SC-05D 5” COLLAR WITH DAMPER

SC-06 6” COLLAR

SC-06D 6” COLLAR WITH DAMPER

SC-07 7” COLLAR

SC-07D 7” COLLAR WITH DAMPER

SC-08 8” COLLAR

SC-08D 8” COLLAR WITH DAMPER

SC-10 10” COLLAR

SC-10D 10” COLLAR WITH DAMPER*

SC-12 12” COLLAR

SC-12D 12” COLLAR WITH DAMPER*

WHERE To BUYVisit www.speediboot.com

or call 1-866-794-7900 for

more information, to locate a

distributor or request a free

sample. Speedi-Boot prod-

ucts are available across the

U.S. and in key international

markets.

*Currently available with metal damper

TECHNoLoGY BY