Coil HQ12 CMM measurements(before testing in HQM01)

R. Bossert/R. RileyMarch 16, 2011

Coil HQ12 186 mm from lead end looking from lead end

Never tested

Average azimuthal size = +39.5 mils

Average radial size = +3.5 mils

One square = 250 um (10 mils)

Note: This position through saddle

Coil HQ12 186 mm from lead end looking from lead end

Never tested

One square = 100 um (4 mils)

Special measurement to observe details of outside surface

Note: This position through saddle

Coil HQ12 408 mm from lead end looking from lead end

Never tested

Average azimuthal size = +41.2 mils

One square = 250 um (10 mils)

Average radial size = +5.3 mils

Coil HQ12 408 mm from lead end looking from lead end

Never tested

One square = 100 um (4 mils)

Special measurement to observe details of outside surface

Coil HQ12 476 mm from lead end looking from lead end

Never Tested

Average azimuthal size = +41.2 mils

Average radial size = +5.7 mils

One square = 250 um (10 mils)

Coil HQ12 476 mm from lead end looking from lead end

Never tested

One square = 100 um (4 mils)

Special measurement to observe details of outside surface

Note: This position at drilled hole

Coil HQ12 630 mm from lead end looking from lead end

Never Tested

Average azimuthal size = +42.4 mils

Average radial size = +8.1 mils

One square = 250 um (10 mils)

Coil HQ12 630 mm from lead end looking from lead end

Never tested

One square = 100 um (4 mils)

Special measurement to observe details of outside surface

Coil HQ12 742 mm from lead end looking from lead end

Never Tested

Average azimuthal size = 42.8 mils

Average radial size = +7.9 mils

One square = 250 um (10 mils)

Coil HQ12 742 mm from lead end looking from lead end

Never tested

One square = 100 um (4 mils)

Special measurement to observe details of outside surface

Note: This position at drilled hole

Coil HQ12 868 mm from lead end looking from lead end

Never Tested

Average azimuthal size = 42.1 mils

Average radial size = +7.2 mils

One square = 250 um (10 mils)

Coil HQ12 868 mm from lead end looking from lead end

Never tested

One square = 100 um (4 mils)

Special measurement to observe details of outside surface

Coil HQ12 1143 mm from lead end looking from lead end

Never Tested

Average azimuthal size = 38.2 mils

Average radial size = +1.7 mils

One square = 250 um (10 mils)

Note: This position through saddle

Coil HQ12 1143 mm from lead end looking from lead end

Never tested

One square = 100 um (4 mils)

Special measurement to observe details of outside surface

Note: This position through saddle

HQ12 coil size (coil measured before testing)Size in mils (in. x 10-3) over nominal

Coil No. Lead End Body Return End

HQ12 39.5 mils 41.9 mils 38.2 mils