Allegheny Coatings - The leader in the application of corrosion protective coatings.
Coatings Application
description
Transcript of Coatings Application
NEXT ! “FIELD & SHOP
APPLICATION OF COATINGS”
APPLICATION OF COATINGS
FIELD&
SHOP
EQUIPMENT Airless Spray Conventional Spray Brush Roller Electrostatic Plural Component HVLP - High Volume / Low Pressure
AIRLESS 30:1 ratio (minimum).
3 gallons per minute output (minimum).
3/8” I.D. material hose (minimum).
Easy clean tips. Higher production rates than conventional
spray. Plural component units
Fixed ratio Variable ratio
SAFETY !! Operates at high pressures.
CONVENTIONAL Dual regulators 3/8” I.D. material hose (minimum)
50’ material hose length (maximum)
Agitator equipped pot for inorganic zinc primers or metallic filled coatings.
Slower than airless but gives better gun control.
ROLLER Nap type and depth dependent on substrate. Phenolic core for solvent based coatings. Two coats may be required to achieve
recommended dry film thickness and hiding.
Don’t over roll. Finished appearance may vary from that
achieved by spray application and from painter to painter and their experience.
BRUSH Natural bristle for solvent based coatings. Synthetic bristle for water based coatings. Two coats may be required to achieve
recommended dry film thickness and hiding.
Do not over brush. Finished appearance may vary from that
achieved by spray application and from painter to painter and their experience.
FIELD APPLICATION Location of equipment
– As near to area to be coated as possible
– Same level
– Recommended hose sizes
– Keep material hose length as short as possible utilize longer air supply lines from compressor
– Be flexible / open to alternative methods
EXAMPLE: High rise construction -- Put equipment / products etc. on the same level or above
FIELD APPLICATION Mixing / Pot Life
Always mix full units / kits Power mix -- 1/2” air or electric drill with a “Jiffy”
or “Jiffler” type mixer Induction time if required (remember outside
environment) New products (100% Solids) have short pot life:
some as short as 15 to 20 secondsHave equipment set up & painter ready to applyHave mixing set up close to work area
FIELD APPLICATION
Environmental Variations Areas to be coated are at the mercy of “Mother
Nature” Monitor conditions continuously Sudden changes may require special mixing and / or
thinning requirements etc. Heaters / dehumidifiers may be required Wind -- overspray / dryspray Federal / State emission and disposal regulations will
vary and must be taken into account
FIELD APPLICATION
Techniques Airless Conventional Brush / Roller
FIELD APPLICATIONHINTS
Utilize the right equipment to do the job READ and UNDERSTAND the product data sheets,
material safety data sheets and specifications. Don’t assume anything !!
Mix only full kits / units with power mixers. A 2 x 4 won’t do the job !!
Be sure you are mixing the correct components together. Many products have similar names / numbers on the materials.
Use recommended thinners only. Incorrect thinners can be the cause of numerous types of failures.
FIELD APPLICATIONHints
Make sure the spray equipment has the correct size hoses, tips, needles, air caps, filters, etc.
When spraying, regardless of airless or conventional, always use the minimal amount of air or fluid pressure required to apply the coating.
Always apply the coatings at the recommended dry film thickness. “More is not always better”
Always apply each coat as soon as the dry to recoat time as shown on the product data sheet is met.
The longer you wait the greater the possibility of contamination
SHOP APPLICATION
EQUIPMENT Airless Spray Air Assisted Airless Conventional Spray HVLP - High Volume / Low Pressure
Electrostatic Plural Component
PLURAL COMPONENT
Fixed Ratio• 1:1, 2:1, 3:1, 4:1
Varible Ratio• 1:1 through 20:1
PLURAL COMPONENT
VARIABLE RATIO
SHOP & FIELD APPLICATION
DON’T ASSUME ANYTHING
IF NOT SURE SEEK THE INFORMATION NEEDED
Case histories & documentation estimate that approximately 80% to 90% of all coating failures are
related to the application of the coating.
QUESTIONS ??QUESTIONS ??
THAT’STHAT’SALLALL
FOLKS !FOLKS !