Coating Project Update
-
Upload
ignatius-eaton -
Category
Documents
-
view
31 -
download
1
description
Transcript of Coating Project Update
![Page 1: Coating Project Update](https://reader036.fdocuments.in/reader036/viewer/2022062422/568130e6550346895d96ff3d/html5/thumbnails/1.jpg)
Coating Project UpdateCoating Project Update
Gregory Harry Gregory Harry Massachusetts Institute of TechnologyMassachusetts Institute of Technology
- On Behalf of the Coating Working Group -- On Behalf of the Coating Working Group -
August 16, 2006August 16, 2006LSC Meeting – Baton RougeLSC Meeting – Baton Rouge
LIGO-G060384-00-RLIGO-G060384-00-R
![Page 2: Coating Project Update](https://reader036.fdocuments.in/reader036/viewer/2022062422/568130e6550346895d96ff3d/html5/thumbnails/2.jpg)
Titania doped Titania doped Tantala/SilicaTantala/Silica
TNI Measurement
coat|| = 8.5 10-5
BNS Range 205 +/- 10 MpcBBH Range 1110 +/- 50 MpcStochastic 1.1 +/- 0.1 10-9
Q Measurement
coat||= 1.6 10-4
BNS Range 190 +/- 10 MpcBBH Range 1040 +/- 50 MpcStochastic 1.1 +/- 0.1 10-9
![Page 3: Coating Project Update](https://reader036.fdocuments.in/reader036/viewer/2022062422/568130e6550346895d96ff3d/html5/thumbnails/3.jpg)
3
Thin Sample – Run 1Bubble, 50/50, 4.3 m, 87
GPa fmode Q 2808 5.7 105 3.1 10-4
2811 4.3 105 4.1 10-4
4250 5.2 105 3.2 10-4
6393 5.8 105 3.0 10-4
6395 5.9 105 3.0 10-4
9835 5.1 105 3.2 10-4
Thin Sample – Run 2 65/35, 4.8 m, 73 GPa
fmode Q 2809 9.2 105 1.8 10-4
4239 7.8 105 2.2 10-4
6391 8.6 105 2.1 10-4
6394 9.5 105 1.9 10-4
9808 8.4 105 2.1 10-4
Full frequency analysis of thick samples gives at 100 Hz:
= 2.4 +/- 0.9 10-4 Absorption IndexRun 1 1.5 ppm 2.15Run 2 0.5 ppm 1.85
XPS analysis at CSIRO shows about 50% SiO2, 50% TiO2, with 0.1% Ta from support wire for Run 1.
Thick Sample – Run 1 fmode Q20225 5.01 +/- 0.0976 106
28475 4.30 +/- 0.114 106 47448 7.30 +/- 0.357 106 73558 4.56 +/- 0.146 106
Silica doped Silica doped Titania/SilicaTitania/Silica
![Page 4: Coating Project Update](https://reader036.fdocuments.in/reader036/viewer/2022062422/568130e6550346895d96ff3d/html5/thumbnails/4.jpg)
Coating ComparisonCoating Comparison
Titania doped Tantala/Silica Young’s modulus higher than
silicaHigh index -> Less layersWorking on bringing absorption
< 1 ppm
BNS Range 190 +/- 10 MpcBBH Range 1040 +/- 50 MpcStochastic 1.1 +/- 0.1 10-9
Silica doped Titania/Silica Young’s modulus close to silicaLow index -> More layersDemonstrated absorption 0.5
ppmNeed information on scatter
BNS Range 165 +/- 10 MpcBBH Range 910 +/- 50 MpcStochastic 1.3 +/- 0.1 10-9
Reach very sensitive to index and Y
![Page 5: Coating Project Update](https://reader036.fdocuments.in/reader036/viewer/2022062422/568130e6550346895d96ff3d/html5/thumbnails/5.jpg)
5
Pure TantalaPure Tantala
Thin Sample ResultsCSIRO 1.8 m
f (Hz) Mode 7 2674 5.8 10-4
Mode 8 2674 5.5 10-4
Mode 9 4032 6.2 10-4
Mode 10 6094 6.1 10-4
Mode 12 9340 6.2 10-4
Thin Sample Results CSIRO 4.65 m, -220 MPa
Stress f (Hz) Mode 7 2707 1.3 10-3
Mode 8 2709 9.3 10-4
Mode 9 4088 8.7 10-4
Mode 10 6168 8.5 10-4
Mode 12 9423 9.9 10-4
Thin Sample ResultsCSIRO 4.65 m,
unannealed f (Hz) Mode 7 2719 1.5 10-3
Mode 8 2720 1.6 10-3
![Page 6: Coating Project Update](https://reader036.fdocuments.in/reader036/viewer/2022062422/568130e6550346895d96ff3d/html5/thumbnails/6.jpg)
6
ERAU Coating Q SetupERAU Coating Q Setup
• Mach-Zender interferometer readout•Cancels low frequency modes•More sensitive than birefringence
• Thin sample, monolithic welded silica suspension• Making measurements this week
![Page 7: Coating Project Update](https://reader036.fdocuments.in/reader036/viewer/2022062422/568130e6550346895d96ff3d/html5/thumbnails/7.jpg)
Silica doped Silica doped Tantala/SilicaTantala/Silica
Thin Sample Results35/65 Si/Ta - CSIRO
f (Hz) Q 2806 5.2 105 3.3
10-4
2812 5.0 105 3.5 10-4
4241 4.7 105 3.5 10-4
6387 5.0 105 3.5 10-4
6397 4.9 105 3.5
10-4
9817 4.7 105 3.5 10-4
n = 1.9Y = 76 GPaAnnealed 24 h at
600 C
BNS Range 150 Mpc
![Page 8: Coating Project Update](https://reader036.fdocuments.in/reader036/viewer/2022062422/568130e6550346895d96ff3d/html5/thumbnails/8.jpg)
8
Q Measurements in Q Measurements in ProgressProgress
•Nitrogen atmosphere annealed poor stoichiometry sample
•Determine effect of poor stoichiometry independantly of annealing state•Poor stoichiometry annealed in air gave worse mechanical loss than standard stoichiometry•Hobart and William Smith Colleges/ERAU
• Finish thick pure tantala from CSIRO, unannealled
•Higher frequency modes•Mechanical loss versus temperature•Have Q vs Temperature results on silica/tantala sample•MIT
![Page 9: Coating Project Update](https://reader036.fdocuments.in/reader036/viewer/2022062422/568130e6550346895d96ff3d/html5/thumbnails/9.jpg)
1.0E-04
1.5E-04
2.0E-04
2.5E-04
3.0E-04
3.5E-04
4.0E-04
4.5E-04
0 50 100 150 200 250 300 350
Temperature (K)
Ca
lcu
late
d c
oa
tin
g lo
ss
Temperature Dependence of Temperature Dependence of Titania doped TantalaTitania doped Tantala
See talk by Stuart Reid
![Page 10: Coating Project Update](https://reader036.fdocuments.in/reader036/viewer/2022062422/568130e6550346895d96ff3d/html5/thumbnails/10.jpg)
10
Thermorefractive NoiseThermorefractive Noise
= dn/dT = 1.2 10-4
Value from M N Inci, cited by Braginsky
Factor of 10 higher than other amorphous oxides
= dL/dT = - 4.4 10-5
others have found + 3.6 10-6, + 5.0 10-6
Qualitatively, TNI data limits this. Needs to be looked at quantitatively
Assuming Inci is wrong = dn/dT = 1.2 10-5
Coating thermorefractive thermoelastic noises are correlated; add in phase
Need calculation of these noises with optimized thicknesses
![Page 11: Coating Project Update](https://reader036.fdocuments.in/reader036/viewer/2022062422/568130e6550346895d96ff3d/html5/thumbnails/11.jpg)
11
ERAU dn/dT ExperimentERAU dn/dT Experiment• Measure change in reflectivity versus temperature• Use green He-Ne laser at 45 degrees• 100 C change in temperature enough to verify/rule out Inci result for tantala• Can measure dn/dT in titania doped tantala, silica doped tantala, etc.
![Page 12: Coating Project Update](https://reader036.fdocuments.in/reader036/viewer/2022062422/568130e6550346895d96ff3d/html5/thumbnails/12.jpg)
12
Ideas for Future Coating Ideas for Future Coating RunsRuns
• Bring down optical absorption in titania doped tantala• Investigate both promising coatings (TiO2 doped Ta2O5 and SiO2 doped TiO2) from other vendors than developer• Single layers of silica, tantala, titania doped tantala, and silica doped titania from CSIRO• Get TNI mirrors with silica doped titania coating• Three way alloys, based on silica - titania and titania - tantala
• Silica-titania-tantala a good first thought: matching Y to substrate with mechanical loss like titania-tantala would be ideal coating• Alumina, niobia, hafnia possible
• Alumina as a dopant into tantala and titania (and possibly silica?)• Silica, titania, alumina dopants into niobia and/or hafnia• Further investigations of cobalt doped tantala
•Change oxidation state of cobalt•Trinary alloys
• Nitrides
![Page 13: Coating Project Update](https://reader036.fdocuments.in/reader036/viewer/2022062422/568130e6550346895d96ff3d/html5/thumbnails/13.jpg)
Scatter in Advanced Scatter in Advanced LIGO OpticsLIGO Optics
• Scatter in initial LIGO optics high, often > 50 ppm• Does not go down when optics are drag wiped
• Absorption of LHO 4K ITMy, did go down• Scatter is either in coating or on substrate
• Suggestion from LMA/Virgo of small bubbles in coating
• Round trip loss at Virgo very high, ~ 500 ppm• Hard to determine cause; clipping, scatter?
• Advanced LIGO scatter must be below 2 ppm• Titania known to have scatter problems (microcrystals)• Southern University to use Atomic Force Microscope to study scatter points
Scatter ITM04
0
10
20
30
40
50
60
70
80
90
100
1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35 37 39 41 43 45 47
Amount of reading fields
Sca
tter
po
ints
per
fie
ld
![Page 14: Coating Project Update](https://reader036.fdocuments.in/reader036/viewer/2022062422/568130e6550346895d96ff3d/html5/thumbnails/14.jpg)
Modelling of Amorphous Modelling of Amorphous MaterialsMaterials
![Page 15: Coating Project Update](https://reader036.fdocuments.in/reader036/viewer/2022062422/568130e6550346895d96ff3d/html5/thumbnails/15.jpg)
Properties of Amorphous Properties of Amorphous Silica SurfacesSilica Surfaces
In the absence of strain, the Si-O bonds are inert to H2O and NH3, etc. Strained Si-O bonds greatly increase the reactivity by creating acidic and basic adsorption sites on silicon and oxygen. Reactive sites (surface defects) play crucial roles in the surface corrosion Two-membered-ring (TMR) is a surface defect with high abundance
Bunker et al, Surf. Sci. 222, 95 (1989); Bunker et al, Surf. Sci. 210, 406 (1989).………
Water destroys TMR, heating above500 oC restores the TMR, surface dehydroxylation
![Page 16: Coating Project Update](https://reader036.fdocuments.in/reader036/viewer/2022062422/568130e6550346895d96ff3d/html5/thumbnails/16.jpg)
16
Advanced LIGO Mirror Advanced LIGO Mirror Storage CaseStorage Case
• Material: Aluminum• Designed to handle bonded ears• Allows for safe insertion and removal of the mirror • The Teflon spring loaded adjustable stops lock the
mirror and prevents rotation• When the top half of the case is lowered down, two ¼”
rods are screwed into the bottom box and the top is slid down over the screws preventing the mirror from being able to contact the top lid.
![Page 17: Coating Project Update](https://reader036.fdocuments.in/reader036/viewer/2022062422/568130e6550346895d96ff3d/html5/thumbnails/17.jpg)
17
Advanced LIGO Mirror Advanced LIGO Mirror Shipping CaseShipping Case
• Material: Polyethylene resin (molded)• Sealed, waterproof/dust proof case • Purge valve • Roller system• Custom interior foam• Anti-static protection• Removable lid