Clock Source Setting on RTN 620 Transmission
description
Transcript of Clock Source Setting on RTN 620 Transmission
HUAWEI TECHNOLOGIES Co., Ltd.
www.huawei.com
HUAWEI Confidential
Security Level:
Possible Clock Source Setting
on RTN 620 Transmission
Prepared by : Reynaldo R. Delos Reyes
CSD Department – Microwave Transmission
HUAWEI TECHNOLOGIES Co., Ltd. HUAWEI Confidential Page 2
Conventional clock set-up without touching clock source configuration
We began to configure the RTN by tracing up the clocking source coming from BITS when 3G
BTS didn’t locked or synchronized. Most of it are successfully locked after the configuration.
BSC
BITS
2G BTS E1 Traffic + Clocking
on a pair of E1 cable
3G BTS IP Traffic
Clocking
Near-End Far-End
BSC
BITS
2G BTS E1 Traffic + Clocking
on a pair of E1 cable
3G BTS IP Traffic
Clocking
Configure to trace-up the
clock source on PH1 or PD1
board tributary port-1
for all near-end side.
Configure to trace-up the
clock source on IF board
for all far-end side.
HUAWEI TECHNOLOGIES Co., Ltd. HUAWEI Confidential Page 3
Example of clock source configuration on Near-End side
HUAWEI TECHNOLOGIES Co., Ltd. HUAWEI Confidential Page 4
Example of clock source configuration on Far-End side
HUAWEI TECHNOLOGIES Co., Ltd. HUAWEI Confidential Page 5
We add configuration on cross-connection if 3G BTS clocking was connected to RTN E1 board
BSC
BITS
2G BTS E1 Traffic + Clocking
on a pair of E1 cable
3G BTS
IP Traffic
Clocking taken from PD1 port 9
Configure to trace-up the
clock source on PH1 or PD1
board tributary port-1
for all near-end side.
Configure to trace-up the
clock source on IF board
for all far-end side.
Note: The clock source used here was Port-2 instead of Port-1.
There should be no physically traffic connection attached to clock
source because the NodeB clock status become Outscope.
HUAWEI TECHNOLOGIES Co., Ltd. HUAWEI Confidential Page 6
Our 3G BTS can also get clocking from PXC board.
BSC
BITS
2G BTS E1 Traffic + Clocking
on a pair of E1 cable
3G BTS IP Traffic
Clocking
Configure to trace-up the
clock source on PH1 or PD1
board tributary port-1
for all near-end side.
Configure to trace-up the
clock source on IF board
for all far-end side.
Clock Input (RX)
Clock Output (TX)
HUAWEI TECHNOLOGIES Co., Ltd.
www.huawei.com
HUAWEI Confidential
Security Level:
Thank You
www.huawei.com