Circuit Board Installation Instructions

1. Gently push the LED’s of your new circuit board through the holes on the alarm door.

2. Screw in the four circuit board screws.

3. Look at the board to make sure the “Enable” switch is flipped to the right.

4. Snap the four plastic clips onto the new board, making sure they are in exactly the same position as when re-moved. The color of the wires for the three plugs on the upper right side should be in the following order from top to bottom: black – red, white – green and red – black. Failure to complete this step properly will result in damage to your new board.

5. Look at the front of the box to verify that you have lights.

6. If you do not have lights, check to make sure the power supply is plugged into the outlet and that all plastic clips are installed correctly.

7. Obtain a green light by using your control key and move the “Enable” switch to the left. (Enabled position)

8. Close and lock the alarm box.

1. Insert the control key into the lower keyswitch, turn the key to the right and hold for approximately 3 seconds until the green LED is lit.

2. Open the alarm door and move the “Enable” switch, located on the circuit board, to the right. (Disabled position)

3. Make note of the position and the colors of the wires terminated in the three vertical plastic clips. Gently separate all four plastic clips from the circuit board by pushing down on the flared edge with your thumb and pulling the clip straight up with your other thumb and index finger. Do not try to remove the clips by pulling on the wires as they may rip out.

4. Remove all four circuit board screws with a Phillips head screwdriver.

5. While using the index and middle finger of your left hand, gently push on the red and green LED’s on the front of the box. At the same time, use your right hand to hold the sides of the circuit board and gently wiggle it out.

Installation

Please remember your new circuit board is very fragile.

The most common damage to a circuit board during Installation is to the two LED’s on the front. They must be lined up exactly with the holes in the door before pushing your new board into place.

Plastic Clips

Enable Switch

Plastic Clips Mounting Screws

Internal View

1-800-45-ALARM orders@RestaurantSecurity.com

www.RestaurantSecurity.com

Removal