Ch.5 Pictorial Drawings Isometric drawings (6.1 & 6.2) Theory of isometric projection (fig5.9),...
-
date post
20-Dec-2015 -
Category
Documents
-
view
235 -
download
4
Transcript of Ch.5 Pictorial Drawings Isometric drawings (6.1 & 6.2) Theory of isometric projection (fig5.9),...
Ch.5 Pictorial Drawings
Isometric drawings (6.1 & 6.2) Theory of isometric projection (fig5.9), Position of isometric axes (fig6.10 to 12), Standards for hidden lines, center lines, and dimensioning (fig6.13 to 15), isometric drawing construction (fig6.17 to 42)
Oblique drawings (6.3) Oblique projection theory & classification (fig6.46 to 50), object orientation rules (fig5.51 to 55), dimensioning (fig6.65), oblique drawing construction (fig6.56 to 64)
Perspective drawings (6.4-6.7) Perspective vs. orthogonal (fig6.69), vanishing point position and ground line position (fig6.17 & 6.73), classification of perspective drawing (fig6.74), perspective drawing variables selection (6.7).
Objective: Learn how to construct three types of pictorial drawings – Isometric, oblique, and perspective
Isometric drawings Depending on where you place isometric
axes, you get different views (Use the most effective position to meet your need)
About isometric and non-isometric lines and planes
True-length distances can only be measured along isometric lines, that is, lines run parallel to any of the isometric axes.
Dealing with hidden lines and center lines in isometric drawingsHidden lines are omitted unless they are absolutely necessary. Center lines are drawn only for showing symmetry or for dimensioning. Normally center lines are not shown.
Constructing an isometric drawing using the Boxing-In method
Box in from the outmost shape to inside details.
What if you have non-isometric lines?
Remember that true-length distances can only be measured along isometric lines, that is, lines run parallel to any of the isometric axes.
Oblique Drawings
Oblique projection is a form of parallel projection in which the projectors are parallel to each other but are not perpendicular to the projection plane.
Common oblique angles
Some hints to select the most important object face
In oblique projection, first, the object face that is placed parallel to the frontal plane will be drawn true size and shape.
Dimensioning in oblique drawings In oblique drawings, dimensions lie in
the plane of the surface to which they apply, and unidirectional text placement is used.
Dimension text may need to be changed because only the cavalier oblique projection gives true depth.
Constructing an oblique drawing using the Offset Coordinate method
When we have arcs and curves, this method is always the easiest method.
Perspective drawings
Terms that you want to be familiar with: horizon line, ground line, station point, picture plane (projection plane), and vanishing point.