CFD Apps: User Guide for the Urban Wind Study App
-
Upload
julien-de-charentenay -
Category
Technology
-
view
1.267 -
download
5
description
Transcript of CFD Apps: User Guide for the Urban Wind Study App
CFD Apps, a Webportal for CFD Modelling
Urban Wind Study User Guide
Outline
1.Geometry Preparation
2.Analysis Submission
Geometry Preparation
Z
XAlign all building with ground
plane.
The App assumes flat ground plane located at the lowest z coordinate of the submitted geometry.
Geometry Preparation
X
YZ
North
When preparing the geometry, remember that:• North is aligned with the y direction;• The z-direction is the up-direction (i.e towards the sky).
Geometry Preparation
• If submitting geometry using STL file format:• Use meter units;• Use a ZIP archive with multiple STL files if required or easier.
• If submitting geometry using the SketchUp file format:
• Just make sure that the geometry is properly prepared as mentioned previously;
• Groups and components are acceptable, but just keep the number of them in the top level small...
Analysis Submission
URL: https://cfdapps.appspot.com
Analysis Submission
Enter your email address
Select the geometry file
Enter scenario parameters for up to 6 scenarios:
Wind speed;Wind height (ie the height
at which the wind speed occurs);Wind direction.
Click Cancel to close the Appor
Submit to proceed to the next step.
Analysis SubmissionSelect the analysis type from:
Analyse: Run the analysis. Payment will be processed through PayPal unless you
are registered for invoicing;
Analyse - Free Trial: Run the analysis at no cost provided that you are registered
for trial and have not yet used all the trial analysis. Registration is required
prior to submitting the analysis.
OpenFoam Setup: Prepare a openFoamsetup corresponding to the scenario(s)
submitted at no cost.
Cancel: Cancel the analysis.
Analysis Submission
Confirmation that the analysis has been submitted (or canceled) and will be processed shortly.
Analysis SubmissionOnce the analysis is submitted you should receive emails similar to the one shown below - openFoam Setup analysis will be slightly different:
Confirmation of simulation start.There is one simulation per
scenario
Confirmation the analysis submission including scenario
parameters
Link to CFD simulation results for download and local post-
processing
Link to result webpage showing automatic simulation post-
processing