Baldwin Centipede Drawbar Installation

1. Place drawbar onto trailing truck assembly of the lead unit as shown:

4. Fit washer over spacer and screw down with included screw. Do not over tighten.

2. Locate spacer, washer and screw - included with the drawbar.

5. Couple the units together as shown below. It is not necessary to screw anything in on the trailing unit. The units are ready to run as shown.

In some rare cases where track work is rough or irregular, you may choose to screw down the trailing unit draw bar - or if you plan to keep the units permanently coupled.

6. Enjoy your new Centipede locomotive.

3. Place spacer over outermost drawpar post as shown below. You may want to use tweezers.

SPACER WASHER

SCREW